Fault location in an HV cable is done by – McqOptions

MCQOPTIONS

1.	Fault location in an HV cable is done by
A.	Voltage withstand test
B.	Partial discharge scanning tests
C.	Life tests
D.	Impulse testing
Answer» C. Life tests

Discussion

No Comment Found

Related MCQs

A static synchronous series compensator injects:
Directions: It consists of two statements, one labelled as the ‘Statement (I)’ and the other as ‘Statement (II)’. You are to examine these two statements carefully and select the answer using the codes given below:Statement (I): No compensation is needed in HVDC lines, unlike EHV-AC system where series and/or shunt compensation is required.Statement (II): Charging current is absent in HVDC system.
Directions: It consists of two statements, one labeled as the ‘Statement (I)’ and the other as ‘Statement (II)’. Examine these two statements carefully and select the answer using the codes given below:Statement (I): HVDC transmission is advantageous over HVAC for large power transfer over long lines.Statement (II): HVDC requires conversion equipment at two ends of the transmission line.
High voltage DC (HVDC) transmission is mainly used for
Identify a valid disadvantage of HVDC transmission lines.
A bipolar, two terminal HVDC link has a 12-pulse converter per pole at each end. The system rating is 1200 MW at ± 500 kV at rectifier end. Line reactance per pole is 4 Ω. The link current will be
Back to back HVDC is used to
Fault location in an HV cable is done by
A bipolar DC line has _________ conductor(s).
Consider the following advantages with respect of HVDC transmission:1. Long distance transmission2. Low cost of transmission3. Higher efficiencyWhich of the above advantages are correct?