______________ fall is adopted for smaller discharges and larger drop – McqOptions

MCQOPTIONS

1.	______________ fall is adopted for smaller discharges and larger drops.
A.	Ogee fall
B.	Sarda fall
C.	Glacis fall
D.	Well-type fall
Answer» E.

Discussion

No Comment Found

Related MCQs

The discharge formula used in the design of the syphon well drop is ____________
Which of the following loss is not considered while calculating the total head loss between the inlet well and D/s FSL?
Calculate the diameter of the inlet well if the X and Y coordinate of the jet (issuing from the centre of pressure) w.r.t the water surface in the inlet well is 1.05 m and 1.88 m respectively.
What is the height of the centre of pressure above the water level in the inlet well if the R.L of the centre of pressure is 150.83 m and the R.L of water level in inlet well is 148.30 m?
Calculate the velocity over the notch (V1) and the velocity through the pipe (V3) if the full supply discharge is 2 cumecs. The area of flow over the trapezoidal notch is 0.58 m2. Assume the value of diameter of the pipe used as 1 m.
Consider the following statements.I. Syphon falls are commonly used where high levelled small drains do out-fall into a low levelled bigger drain.II. The D/s well is necessary in case of falls greater than 1.8 m and for discharges greater than 0.29 cumecs.III. The design discharge is determined based on the fact that V-notch is used.Which of the following statement is correct?
______________ fall is adopted for smaller discharges and larger drops.