Endurance limit of a beam subjected to pure bending decreases with – McqOptions

MCQOPTIONS

1.	Endurance limit of a beam subjected to pure bending decreases with
A.	decrease in the surface roughness and decrease in the size of the beam
B.	increase in the surface roughness and decrease in the size of the beam
C.	increase in the surface roughness and increase in the size of the beam
D.	decrease in the surface roughness and increase in the size of the beam
Answer» D. decrease in the surface roughness and increase in the size of the beam

Discussion

No Comment Found

Related MCQs

A maximum of how many rods may be connected using a knuckle joint?
If t, ζ and P are thickness, permissible shear stress and applied axial load respectively on a cotter joint, the mean width of the collar is equal to.
For a plate with an elliptical hole subjected to tensile stress, σ as shown in the figure, the maximum tensile stress at point P is
For the given material, if the stress concentration factor is 2 and Notch sensitivity is 0.1, then the fatigue stress concentration factor is:
Abrupt change of cross section in a member subject to load can result in __________.
A rectangular bar with a circular hole is to be made of a material with actual maximum permissible stress of 150 MPa. If stress concentration factor for the configuration is 3.0, what is the nominal average stress for sizing the section?
Endurance limit of a beam subjected to pure bending decreases with