Due to which of the following reasons excessive bond width in control – McqOptions

MCQOPTIONS

1.	Due to which of the following reasons excessive bond width in control systems should be avoided ?
A.	It leads to slow speed of response
B.	It leads to low relative stability
C.	Noise is proportional to band width
D.	None of the above
Answer» D. None of the above

Discussion

No Comment Found

Related MCQs

In closed loop control system, with positive value of feedback gain the overall gain of the system will
A control system in which the control action is somehow dependent on the output is known as
A car is running at a constant speed of 50 km/h, which of the following is the feedback element for the driver ?
By which of the following the control action is determined when a man walks along a path ?
As a result of introduction of negative feedback which of the following will not decrease ?
When the initial conditions of a system are specified to be zero it implies that the system is
The transfer function technique is considered as inadequate under which of the following conditions ?
Due to which of the following reasons excessive bond width in control systems should be avoided ?
A signal other than the reference input that tends to affect the value of controlled variable is known as
Which of the following is the best method for determining the stability and transient response ?