directives are used to initialize operands. – McqOptions

MCQOPTIONS

Saved Bookmarks

→ Computer Science Engineering (CSE)
→ Software Design Modeling
→ directives are used to initialize operands.

1.	directives are used to initialize operands.
A.	int
B.	dataword
C.	reserve
D.	dcd
Answer» E.

Discussion

No Comment Found

Related MCQs

The bit is used to indicate the validity of the page.
BUS arbitration approach uses the involvement of the processor.
The read and write operations usually start at of the sector.
The cache bridges the speed gap between and
The multiplier is stored in
In LRU, the referenced blocks counter is set to’0′ and that of the previous blocks are incremented by one and others remain same, in the case of
In a 4M-bit chip organisation has a total of 19 external connections.then it has address if 8 data lines are there.
In the output interface of the parallel port, along with the valid signal is also sent.
The is used to coordinate the operation of the multiplier.
The only difference between the EEPROM and flash memory is that the latter doesn’t allow bulk data to be written.

Related Topics

Software Design Modeling

Information Cyber Security

Software Testing And Quality Assurance

Neural Networks And Fuzzy Control

Digital Logic Circuits

Object Oriented Programming

Usability Engineering

Artificial Intelligence And Robotics

Computer Networking

Data Analysis

Recent Visits

Reply to Comment

Name *

Email *

Comment *

© Copyright 2025 McqOptions. All rights reserved.

Terms & Conditions
Privacy Policy
Disclaimer
Contact Us