DEVELOPMENT_OF_EARLY_CRACKS_IN_REINFORCED_CONCRETE_IS_DUE_TO:?$

1.	DEVELOPMENT_OF_EARLY_CRACKS_IN_REINFORCED_CONCRETE_IS_DUE_TO:?$
A.	Strains of steel
B.	Stresses of steel
C.	Ultimate load
D.	Bending of steel
Answer» B. Stresses of steel

Discussion

No Comment Found

Related MCQs

A system undergoing change in state from A to B along path ‘X’ receives 100 J heat and does 40 J work. It returns to state A from B along path ‘Y’ with work input of 30 J. Calculate the heat transfer involved along the path ‘Y’.
A sealed rigid vessel has volume of 1 m3 and contains 2 kg of water at 100°C. The vessel is now heated. If a safety pressure valve is installed, at what pressure should the valve be set to have a maximum temperature of 200°C ?
Calculate the change in enthalpy of carbon dioxide from 30 to 1500°C at 100 kPa at constant specific heat.
A piston-cylinder device initially contains air at 150 kPa and 27°C. At this state, the volume is 400 litre. The mass of the piston is such that a 350 kPa pressure is required to move it. The air is now heated until its volume has doubled. Determine work done by the air.
A piston-cylinder device initially contains air at 150 kPa and 27°C. At this state, the volume is 400 litre. The mass of the piston is such that a 350 kPa pressure is required to move it. The air is now heated until its volume has doubled. Determine the final temperature.
The pressure gauge on an air tank shows 60 kPa when the diver is 8 m down in the ocean. At what depth will the gauge pressure be zero?
Find the pressure of water at 200°C and having specific volume of 1.5 m3/kg.
A 5 m long vertical tube having cross sectional area 200 cm2 is placed in a water. It is filled with 15°C water, with the bottom closed and the top open to 100 kPa atmosphere. What is the pressure at the bottom of tube?
A 5 m long vertical tube having cross sectional area 200 cm^2 is placed in a water. It is filled with 15°C water, with the bottom closed and the top open to 100 kPa atmosphere. How much water is present in tube?
A piston/cylinder with a cross-sectional area of 0.01 m^2 is resting on the stops. With an outside pressure of 100 kPa, what should be the water pressure to lift the piston?

DEVELOPMENT_OF_EARLY_CRACKS_IN_REINFORCED_CONCRETE_IS_DUE_TO:?$

Discussion

No Comment Found

Related MCQs

Reply to Comment