CRO (Cathod Ray Oscilloscope) CANNOT be used to measure _______. – McqOptions

MCQOPTIONS

1.	CRO (Cathod Ray Oscilloscope) CANNOT be used to measure _______.
A.	frequency
B.	phase
C.	power
D.	voltage
Answer» D. voltage

Discussion

No Comment Found

Related MCQs

In an oscilloscope screen, Linear sweep signal is applied at the
A 1000 Hz sinusoidal voltage is connected to both X and Y inputs of a CRO. Which of the following waveforms is seen on CRO ?
A stationary closed Lissajous pattern on an oscilloscope has 3 horizontal tangencies and 2 vertical tangencies for a horizontal input with frequency 3 kHz. The frequency of the vertical input is
CRO (Cathod Ray Oscilloscope) CANNOT be used to measure _______.
Decibel scale is useful while measuring voltages covering
A voltage of 6 cos(100πt) V is fed as y-input to a CRO. The waveform seen on the screen of the CRO is shown in the figure. The Y and X axes settings for the CRO are respectively
Astigmatism control on CRO panel is used for ______ control.
One cycle of square wave signal observed on an oscilloscope is found to occupy 6 cm at a scale setting of 30 μs/cm. What is the signal frequency?