Conicity resulting after machining by Ultrasonic Machining can be redu – McqOptions

MCQOPTIONS

1.	Conicity resulting after machining by Ultrasonic Machining can be reduced by?
A.	Direct injection of slurry
B.	Tools having negative taper
C.	High static pressure
D.	All of the mentioned
Answer» E.

Discussion

No Comment Found

Related MCQs

WHICH_OF_THE_FOLLOWING_FACTORS_AFFECT_THE_SURFACE_FINISH_OF_MACHINED_PARTS_IN_ULTRASONIC_MACHINING??$
When the viscosity of liquid carrier is increased, the surface quality of the parts?$
What is value of surface finish achieved, when we use the abrasive of grit number 240?$
Typical roundness error in graphite, resulted due to lateral vibrations is between?
Conicity resulting after machining by Ultrasonic Machining can be reduced by?
Of the following, USM accuracy levels are limited to which value?
While machining B4C, tool over cut size when compared to mean grain size is?
While machining W4C and glass, tool over cut size when compared to mean grain size is?
Of the following factors, which one affects the accuracy of parts?
Which of the following distribution factors, does not affect the machining parts?