Coefficient of friction is minimum at – McqOptions

MCQOPTIONS

Saved Bookmarks

→ Machine Design
→ Stress Concentration Factors
→ Coefficient of friction is minimum at

1.	Coefficient of friction is minimum at
A.	It is same at each point
B.	B
C.	C
D.	D
Answer» C. C

Discussion

No Comment Found

Related MCQs

Transverse fillet weld can be designed using the same equations as of parallel fillet weld.
A single transverse weld is preferred over double transverse fillet weld.
The fundamental equation for viscous flow is given by ∆pbhᵌ/6µl where symbols have their usual meanings.
A_SINGLE_TRANSVERSE_WELD_IS_PREFERRED_OVER_DOUBLE_TRANSVERSE_FILLET_WELD.?$
The fundamental equation for viscous flow is given by ‚Äö√Ñ√∂‚àö‚Ä†‚àö√∫pbh¬¨‚àë¬¨¬µ‚àö‚Ä¢/6¬¨¬®¬¨¬µl where symbols have their usual meanings?#
If viscosity of the lubricant is very low than BCN will lie in the region
Bearing modulus is the bearing characteristic number at
Coefficient of friction is minimum at
Hydrodynamic lubrication takes place in region?
In the graph shown, which regions points the partial metal to metal contact.

Related Topics

Stress Concentration Factors

Worm Gears

Friction Clutches

Transmission Shafts

Belt Tensioning Methods

Concentric Spiral Springs

Coeffecient Flywheel

Belt Constructions

Principal Stresses Theories Failure

Cotter Joint

Recent Visits

Reply to Comment

Name *

Email *

Comment *

© Copyright 2025 McqOptions. All rights reserved.

Terms & Conditions
Privacy Policy
Disclaimer
Contact Us