Chain and sprocket drive is preferred, when two parallel shafts are pl – McqOptions

MCQOPTIONS

1.	Chain and sprocket drive is preferred, when two parallel shafts are placed at a distance of _______
A.	5 m
B.	2 m
C.	10 m
D.	4 m
Answer» C. 10 m

Discussion

No Comment Found

Related MCQs

The chain drive is used to reduce the speed from 180 rpm to 90 rpm, the driving sprocket has 20 teeth and pitch circle diameter of 500 mm. The centre to centre distance between the sprockets of chain drive is 550 mm. Determine total number of links.
A 20 teeth sprocket is operating at 150 rpm and driving a 43 teeth sprocket through a chain. The pitch of the chain is 250 mm and alternate strength is 10 KN. Determine the average torque applied to driven shaft at maximum power transmission.
Perfect velocity ratio is obtained in ________
Chain and sprocket drive is preferred, when two parallel shafts are placed at a distance of _______
Pitch length of standard chain number 40 is ________
Pintle chains are made of ________
In chain drives, for higher speed and loads, suitable chains to be used are ______
In chain drives the component with a cast throttled wheel is known as _______
Which of the following rollers are used for external drive?
Chain and sprocket drive is used, where _____________