Can the setup() function change the value of constant variables? – McqOptions

MCQOPTIONS

1.	Can the setup() function change the value of constant variables?
A.	Yes, it can change
B.	No, it cannot change
C.	Yes, it can change but only integer values
D.	Yes, it can change but only byte values
Answer» C. Yes, it can change but only integer values

Discussion

No Comment Found

Related MCQs

What is the signal generated by the code at ‘y’ below if the input to ‘x’ is given as 1100?
If we would require a technique which would be able to run the setup() function for ‘n’ times, which one would we use? Choose the correct Combination that works.
How many times will the code run?
What do we need to do if we want to run the setup() function in an infinite loop?
What are the errors in the code given below?
What is the output of the following code if the input voltage to pin1 is 0V,3.3V, 3.2V, and 5V (assuming 0V – 0, 3.2V – 492, 3.3V – 501, 5V -1023)?
Given below are 2 snippets of code. Which one(s) are/is correct in order to generate an output signal of the form given below?a.
Is it syntactically correct to write the loop() function over the setup() function while writing an Arduino program?
Can the setup() function change the value of constant variables?
How many times does the setup() function run on every startup of the Arduino System?