Calculate the minimum modular head loss involved in ASOM if the head – McqOptions

MCQOPTIONS

1.	Calculate the minimum modular head loss involved in ASOM if the head measured from the upstream water level in the distributary is 1.5 m and the width of the throat as 0.16 m.
A.	1.50 m
B.	1.15 m
C.	1.07 m
D.	1.00 m
Answer» C. 1.07 m

Discussion

No Comment Found

Related MCQs

For a wide trapezoidal channel, the channel index is ______
Choose the incorrect advantage of AOSM.
The principal feature of an ASOM is similar to those of a flume regulator.
An irrigation outlet is said to be proportional, when its ______________
The only irrigation semi-module through which the discharge is not proportional to H1/2 where H is the head causing flow through the module is _____________
Calculate the discharge through an open flume outlet for the following data:Coefficient of discharge = 1.71Width of the throat = 0.15 mHead over the crest measured from FSL of distributary = 1.8 m
The proportionality of APM was sacrificed to enable the outlet to carry higher silt charge by increasing the setting to 8/10.
Calculate the minimum modular head loss involved in ASOM if the head measured from the upstream water level in the distributary is 1.5 m and the width of the throat as 0.16 m.
Which module is mostly adopted and is considered to be the best of all the modules?
Calculate full supply discharge for a free pipe outlet for the following data.Head on the upstream side above the centre line of pipe = 0.55 mCoefficient of discharge = 0.62The diameter of the pipe = 25 cm