Antenna that does not belong to the horn antenna family among the foll – McqOptions

MCQOPTIONS

1.	Antenna that does not belong to the horn antenna family among the following are:
A.	Pyramidal horn
B.	Conical horn
C.	bi-conical horn
D.	None of the mentioned
Answer» E.

Discussion

No Comment Found

Related MCQs

If the length of aperture in a pyramidal horn antenna is 10cm and δ for the design is 0.25. Then, the flaring angle of the pyramidal horn is:
The terminal impedance of a dipole antenna is 710 Ω. The terminal impedance of the slot antenna given the intrinsic impedance of air is 377 Ω is:
______ antennas have gain less than reflector antennas but have more lenient tolerance on surfaces.
LENS_ANTENNAS_ARE_CLASSIFIED_INTO_TWO_TYPES._ONE_BEING_FAST_ANTENNA,_THE_OTHER_ONE_IS:?$
High directivity required in RADAR communication is satisfied using this type of antennas:$
The_antennas_which_offer_high_operational_bandwidth_and_the_antenna_parameters_are_maintained_over_a_wide_range_of_antennas_are_called:$
If the directivity of a square corner receiving antenna is 20 and operating at a wavelength of 0.25m, the effective aperture of a square corner antenna is:
If the length of aperture in a pyramidal horn antenna is 10cm and ‚âà√≠¬¨‚Ä¢ for the design is 0.25. Then, the flaring angle of the pyramidal horn is:$
The_terminal_impedance_of_a_dipole_antenna_is_710_‚âà√≠¬¨¬©._The_terminal_impedance_of_the_slot_antenna_given_the_intrinsic_impedance_of_air_is_377_‚âà√≠¬¨¬©_is:$
______ antennas have gain less than reflector antennas but have more lenient tolerance on surfaces?