An amplifier with mid-band gain | A| = 500 has negative feedback = 1 – McqOptions

MCQOPTIONS

→

An amplifier with mid-b..

1.

An amplifier with mid-band gain | A| = 500 has negative feedback = 1 .If upper cut-off without
100

feedback were at 60 Hz, then with feedback it would become _________ kHz .

A.

360

B.

40

C.

160

D.

180

Answer» B. 40

Discussion

No Comment Found

Related MCQs

An 8 bit unipolar successive approximation register type ADC is used to convert 3.5V to digital equal output. The reference voltage is +5V. The output of ADC at end of 3<sup>rd</sup> clock pulse after the start of conversion is .......... .
A 4<sup>1</sup> / <sub>2</sub> digit DMM has the error specification as: 0.2% of reading +10 counts. If a dc voltage of 100 V is read on its 200 V full scale, the maximum error that can be expected in the reading is
Two 8-bit ADCs, one of single slope integrating type and other of successive approximation type, take T<sub>A</sub> and T<sub>B</sub> times to convert 5 V analog input signal to equivalent digital output. If the input analog signal is reduced to 2.5V, the approximate time taken by the two ADCs will respectively, be<br>
For a class B amplifier providing a 20 V peak signal to 16&ohm; load and a power supply of V<sub>cc</sub> = 30 V, efficiency will be _____ % .
If input signal e<sub>i</sub> applied to the OP-AMP of the circuit shown in the given figure is sinusoidal at maximum value 1 mV and of 1kHz frequency, then magnitude of the peak value of the output voltage waveform would be _________ mV .
Of the four characteristic given below, what are major requirements for an instrument amplifier? <br>P : high common mode rejection ratio <br>Q : high input impedance <br>R : high linearity <br>S : high output impedance
<table><tr><td rowspan="2">An amplifier with mid-band gain | A| = 500 has negative feedback = </td><td style="border-bottom:1px solid #000000;vertical-align:bottom;padding-bottom:2px;"><center>1</center></td><td rowspan="2"> .If upper cut-off without</td></tr><tr><td style="text-align: center;">100</td></tr></table><br> feedback were at 60 Hz, then with feedback it would become _________ kHz .
For a transistor, parameters are = 180 and V<sub>A</sub> = 150V, and it is biassed at I<sub>CQ</sub> = 2m A. If collector of the tansistor is connected to the base terminal, t hen small signal resistaance r<sub>e</sub> = v<sub>ce</sub>/ i<sub>c</sub> of this two-terminal device is ____ &ohm; .
A CE amplifier has a resistor R<sub>F</sub> connected between collector an d base R<sub>F</sub> = 40 k. R<sub>C</sub> = 4k. I f h<sub>fe</sub> = 50, r<sub> </sub> = 1 k, then output resistance R<sub>0</sub> is _______ k&ohm; .
If = 0.98, I<sub>CO</sub> = 6 A and I<sub> </sub> = 100 A for a transistor, then value of I<sub>C</sub> will be _______ mA