A transmission and distribution engineer needed to design the sub tran – McqOptions

MCQOPTIONS

1.	A transmission and distribution engineer needed to design the sub transmission substation. The tapping component needed will be _______________
A.	feeder
B.	distributor
C.	transmitter
D.	tap-changing transformer
Answer» B. distributor

Discussion

No Comment Found

Related MCQs

FOR_THE_SINGLE_PHASE_2-WIRE_SYSTEM,_THE_MAXIMUM_VOLTAGE_BETWEEN_THE_OUTER_WIRES_AND_EARTH_IS_______________?$
For_the_given_distribution_system_the_maximum_voltage_at_the_midpoint_will_be_________$
A DC 2-wire system with mid-point earthed having cross-sectional area of each conductor be ‚Äö√Ñ√∂‚àö√ë‚àö‚â§a‚Äö√Ñ√∂‚àö√ë‚àö¬• and resistance ‚Äö√Ñ√∂‚àö√ë‚àö‚â§R1‚Äö√Ñ√∂‚àö√ë‚àö¬•. If this is replaced by monopolar system, then saving of copper will be _____?#
While designing the distribution sub stations by the designer, it is required to use the _______ for the discrete power tapping.
A DC 2-wire system with mid-point earthed having cross-sectional area of each conductor be ‚Äö√Ñ√∂‚àö√ë‚àö‚â§a‚Äö√Ñ√∂‚àö√ë‚àö¬• and resistance ‚Äö√Ñ√∂‚àö√ë‚àö‚â§R1‚Äö√Ñ√∂‚àö√ë‚àö¬•. If the DC tow wire replaces the system, then the ratio of volume of each conductor V1/V2 will be ___________$
A _________ distribution system is more reliable than the ______ distribution system.
While designing the distribution to locality of one lac population with medium dense load requirement, we can employ ___________
A transmission and distribution engineer needed to design the sub transmission substation. The tapping component needed will be _______________