A traction wheel having 600 mm diameter was tested in a soil bin and f – McqOptions

MCQOPTIONS

1.	A traction wheel having 600 mm diameter was tested in a soil bin and following data was obtained, angular speed=10rpm, input torque to wheel angle=60 Nm, drawbar pull=150 N, normal load on wheel axle=500 N, wheel forward speed=0.25 ms-1. What will be the slippage?
A.	19.47%
B.	20.18%
C.	20.43%
D.	19.98%
Answer» D. 19.98%

Discussion

No Comment Found

Related MCQs

How much traction would be generated by the force of 1000N applied by tyre on soil and soil capacity is 2000 N?
What is wheel s force?
A traction wheel having 600 mm diameter was tested in a soil bin and following data was obtained, angular speed=10rpm, input torque to wheel angle=60 Nm, drawbar pull=150 N, normal load on wheel axle=500 N, wheel forward speed=0.25 ms-1. What will be the tractive efficiency?
What is steady state turn?
A 2-wheel drive 35 HP tractor has 1.5 m rear wheel diameter. The engine runs at 1200 rev/min. the total reduction of speed is 30:1. Find the travelling speed of tractor in km/h.
The line of pull on an implement is 20 above the horizontal and in a vertical plane which is at an angle 10 with the direction of travel. What drawbar power would be required at 5km/h
A two-wheel drive tractor is pulling a load of 12 KN horizontally on levelled surface at forward speed of 5km/hr. The rolling radius of traction wheel and wheel slip are 0.65m and 20% respectively. If rear axle torque is 9KNm the tractive efficiency is ______
A traction wheel having 600 mm diameter was tested in a soil bin and following data was obtained, angular speed=10rpm, input torque to wheel angle=60 Nm, drawbar pull=150 N, normal load on wheel axle=500 N, wheel forward speed=0.25 ms-1. What will be the slippage?