A shaft of 50 mm diameter transmits a torque of 800 N-m. The width of the rectangular key used is 10 mm. The allowable shear stress of the material of the key being 40 MPa, the required length of the key would be

A shaft of 50 mm diameter transmits a torque of 800 N-m. The width of

1.	A shaft of 50 mm diameter transmits a torque of 800 N-m. The width of the rectangular key used is 10 mm. The allowable shear stress of the material of the key being 40 MPa, the required length of the key would be
A.	60 mm
B.	70 mm
C.	80 mm
D.	90 mm
Answer» D. 90 mm

Discussion

No Comment Found

Related MCQs

A solid steel shaft of 100 mm diameter and 1.0 m long is subjected to a twisting moment T. This shaft is to be replaced by a hollow shaft having outer and inner diameters as 100 mm and 50 mm respectively. If the maximum shear stress induced in both the shafts is same, the twisting moment T transmitted by hollow shaft must be reduced by
In a flange coupling, the flange bolts are designed for
If a rectangular key of 8 mm width and 6 mm height and a shaft of diameter 32 mm are made of same material, then the necessary length of the key for equal shear strength of shaft and key will be (neglecting stress concentration on the shaft)
__________ can be used to transmit power between two non-parallel and intersecting shafts
A shaft of 50 mm diameter transmits a torque of 800 N-m. The width of the rectangular key used is 10 mm. The allowable shear stress of the material of the key being 40 MPa, the required length of the key would be
A key connecting a flange coupling to the shaft is likely to fail in
In a fully automatic transmission the
A key of 14 mm width, 9 mm height and 100 mm length is mounted on a shaft of 50 mm diameter. If allowable shear stress for the key material is 50 MPa, what is the maximum torque that can be transmitted?
If a solid circular shaft of steel 2 cm in diameter is subjected to a permissible shear stress of 10 kN/cm2, then the value of the twisting moment (Tr) will be)
If the permissible crushing stress for the material of a key is double the permissible shear stress, then the sunk key will be equally strong in shearing and crushing if the key is a

A shaft of 50 mm diameter transmits a torque of 800 N-m. The width of the rectangular key used is 10 mm. The allowable shear stress of the material of the key being 40 MPa, the required length of the key would be

Discussion

No Comment Found

Related MCQs

Reply to Comment