A piston/cylinder has 5m of liquid 20 C water on top of piston with cross-sectional area of 0.1 m2. Air is let in under the piston that rises and pushes the water out. Find the necessary work to push all the water out.

A piston/cylinder has 5m of liquid 20 C water on top of piston with cr

1.	A piston/cylinder has 5m of liquid 20 C water on top of piston with cross-sectional area of 0.1 m2. Air is let in under the piston that rises and pushes the water out. Find the necessary work to push all the water out.
A.	62.88 kJ
B.	52.88 kJ
C.	92.88 kJ
D.	42.88 kJ
Answer» B. 52.88 kJ

Discussion

No Comment Found

Related MCQs

A piston/cylinder contains 1 kg water at 20 C with volume 0.1 m3. While the water is heated to saturated vapour, the piston is not allowed to move. Find the final temperature.
A piston/cylinder has 5m of liquid 20 C water on top of piston with cross-sectional area of 0.1 m2. Air is let in under the piston that rises and pushes the water out. Find the necessary work to push all the water out.
A piston cylinder contains air at 600 kPa, 290 K and volume of 0.01 m3. A constant pressure process gives out 54 kJ of work. Find the final temperature of the air.
A constant pressure piston cylinder contains 0.2 kg water in the form of saturated vapour at 400 kPa. It is now cooled to occupy half the original volume. Find the work in the process.
Ammonia at 10 C with a mass of 10 kg is in a piston-cylinder arrangement with an initial volume of 1 m3. The piston initially resting on the stops has a mass such that a pressure of 900 kPa will float it. The ammonia is now slowly heated to 50 C. Find the work in the process.
10 kg of water in a piston-cylinder exists as saturated liquid/vapour at 100 kPa, with a quality of 50%. It is now heated till the volume triples. The mass of the piston is such that a cylinder pressure of 200kPa will float it. Find the work given out by the water.
A piston-cylinder contains 1 kg of liquid water at 300 kPa, 20 C. Initially the piston floats, with a maximum enclosed volume of 0.002 m3 if the piston touches the stops. Now heat is added so that the final pressure is 600 kPa. Find the work in the process.
Ammonia in a piston/cylinder arrangement is at 80 C, 700 kPa. It is now cooled at constant pressure to saturated vapour (state 2) at which point the piston is locked with a pin. The cooling continues to 10 C (state 3). Find the work.
A piston-cylinder contains 50 kg of water at 200 kPa with V=0.1 m3. Stops in the cylinder restricts the enclosed volume to 0.5 m3. The water is now heated to 200 C. Find the work done by the water.
R-22 is contained in a piston-cylinder, where the volume is 11 L when the piston hits the stops. The initial state is 150 kPa, 30 C with V=10 L. This system warms up to 15 C. Find the work done by R-22 during this process.

A piston/cylinder has 5m of liquid 20 C water on top of piston with cross-sectional area of 0.1 m2. Air is let in under the piston that rises and pushes the water out. Find the necessary work to push all the water out.

Discussion

No Comment Found

Related MCQs

Reply to Comment