A hollow rectangular waveguide cannot propagate TEM waves because: – McqOptions

MCQOPTIONS

1.	A hollow rectangular waveguide cannot propagate TEM waves because:
A.	Of the existence of only one conductor
B.	Of the losses caused
C.	It is dependent on the type of the material used
D.	None of the mentioned
Answer» B. Of the losses caused

Discussion

No Comment Found

Related MCQs

In TE01 mode of wave propagation in a rectangular waveguide, if the smaller dimension of the waveguide is 2 cm, then the cutoff wavelength for that mode is:
In TE10 mode of wave propagation in a rectangular waveguide, if the broader dimension of the waveguide is 40 cm, then the cutoff wavelength for that mode is:
The cutoff frequency for the dominant mode in TM mode propagation for a rectangular waveguide of dimension of 30mm*40mm is:
The lowest mode of TM wave propagation is:
For dominant mode propagation in TE mode, if the rectangular waveguide has a broader dimension of 31.14 mm , then the cutoff wave number:
TEₒₒ mode for a rectangular waveguide:
For TE1ₒ mode, if the waveguide is filled with air and the broader dimension of the waveguide is 2 cm, then the cutoff frequency is:
The modes of propagation supported by a rectangular wave guide is:
THE_LOWEST_MODE_OF_TM_WAVE_PROPAGATION_IS:?$
In TE10 mode of wave propagation in a rectangular waveguide, if the broader dimension of the waveguide is 40 cm, then the cutoff wavelength for that mode is:$