A full wave rectifier supplies a load of 1KΩ. The AC voltage applie – McqOptions

MCQOPTIONS

1.	A full wave rectifier supplies a load of 1KΩ. The AC voltage applied to diodes is 220V (rms). If diode resistance is neglected, what is the ripple voltage?
A.	0.562V
B.	0.785V
C.	0.954V
D.	0.344V
Answer» D. 0.344V

Discussion

No Comment Found

Related MCQs

In a centre tapped full wave rectifier, the input sine wave is 250sin100t. The output ripple frequency will be _________
If the peak voltage on a centre tapped full wave rectifier circuit is 5V and diode cut in voltage is 0.7. The peak inverse voltage on diode is_________
Transformer utilization factor of a centre tapped full wave rectifier is_________
If input frequency is 50Hz for a full wave rectifier, the ripple frequency of it would be _________
In a centre tapped full wave rectifier, RL=1KΩ and for diode Rf=10Ω. The primary voltage is 800sinωt with transformer turns ratio=2. The ripple factor will be _________
A full wave rectifier uses load resistor of 1500Ω. Assume the diodes have Rf=10Ω, Rr=∞. The voltage applied to diode is 30V with a frequency of 50Hz. Calculate the AC power input.
A full wave rectifier delivers 50W to a load of 200Ω. If the ripple factor is 2%, calculate the AC ripple across the load.
A full wave rectifier supplies a load of 1KΩ. The AC voltage applied to diodes is 220V (rms). If diode resistance is neglected, what is the ripple voltage?
Efficiency of a centre tapped full wave rectifier is _________
IN_A_CENTER_TAPPED_FULL_WAVE_RECTIFIER,_THE_INPUT_SINE_WAVE_IS_250SIN100_¬¨‚ÀË¬¨‚Ä¢¬¨√ÜT._THE_OUTPUT_RIPPLE_FREQUENCY_OF_RECTIFIER_WILL_BE___________?$#