A duplex lap wound armature is used in six pole dc machine with six br – McqOptions

MCQOPTIONS

1.	A duplex lap wound armature is used in six pole dc machine with six brush set. The number of current paths in this machine is?
A.	12
B.	6
C.	3
D.	2
Answer» B. 6

Discussion

No Comment Found

Related MCQs

The emf vs speed characteristics of a dc generator is?
Which of the following cannot reduce the terminal voltage of a dc shunt generator?
For a 4 pole 200 V, 20 A dc generator running at the rated rpm with no load will be ________
For a four pole, 200 V dc shunt generator having armature resistance of 1 ohms. The current flowing in the armature is 10 A. What is the back emf generated if the terminal voltage of 220 V supply is fed?
For a four pole, 16 slot armature with two coil-side/slot having wave connected progressive winding has single turn coils has simplex winding. The number of current paths is?
A duplex lap wound armature is used in six pole dc machine with six brush set. The number of current paths in this machine is?
For a four pole, 16 slot armature with two coil-side/slot having lap connected progressive winding has single turn coils. The same machine is then wave wound, the emf induced in the lap wound dc machine to that of wave wound will be ________
If the armature current is by mistake increased to 50% for the dc machine then ________
The induced emf in the armature of a 4-pole dc machine is ________
If the speed of rotation for a four pole, 220V dc machine is 1 m/s, flux density as 2T having length of bore as 0.1m and radius of 0.5m. The emf induced under pole faces will be ________