A cube, sphere & a thin circular plate (all having same mass and made of same material) are all heated to 300Â°C and allowed to cool in natural air. Which one will cool the slowest ?

A cube, sphere & a thin circular plate (all having same mass and made

1.	A cube, sphere & a thin circular plate (all having same mass and made of same material) are all heated to 300Â°C and allowed to cool in natural air. Which one will cool the slowest ?
A.	Cube
B.	Plate
C.	Sphere
D.	All will cool at the same rate
Answer» D. All will cool at the same rate

Discussion

No Comment Found

Related MCQs

The purpose of providing a \'catchall\' in the vapor line of an evaporator is to
In a trimetric drawing, the relationship of the angle between axes to each other is:
What is the geometric mean of two heat transfer areas A 1 and A 2 ?
In a laboratory test run, the rate of drying was found to be 0.5 x 10 -3 kg/m 2 .s, when the moisture content reduced from 0.4 to 0.1 on dry basis. The critical moisture content of the material is 0.08 on a dry basis. A tray dryer is used to dry 100 kg (dry basis) of the same material under identical conditions. The surface area of the material is 0.04 m 2 /kg of dry solid. The time required (in seconds) to reduce the moisture content of the solids from 0.3 to 0.2 (dry basis) is
The overall heat transfer co-efficient for a shell and tube heat exchanger for clean surfaces is U 0 = 400 W/m 2 .K. The fouling factor after one year of operation is found to be h d0 = 2000 W/m 2 .K. The overall heat transfer co-efficient at this time is
Heat transfer co-efficient equation for forced convection, Nu = 0.023 R e 0.8 . P r n , is not valid, if the value of
In a heat exchanger with steam outside the tubes, a liquid gets heated to 45Â°C, when its flow velocity in the tubes is 2 m/s. If the flow velocity is reduced to 1 m/s, other things remaining the same, the temperature of the exit liquid will be
Duhring's plot' is of use in
Value of Nusselt number [ Nu = ( hD / k )] for the heat transfer by conduction from a droplet or a spherical particle to a surrounding stagnant film is
The inner wall of a furnace is at a temperature of 700Â°C. The composite wall is made of two substances, 10 and 20 cm thick with thermal conductivities of 0.05 and 0.1 W.m -1 .Â°C -1 respectively. The ambient air is at 30Â°C and the heat transfer co-efficient between the outer surface of wall and air is 20 W.m -2 .Â°C -1 . The rate of heat loss from the outer surface in W.m -2 is

A cube, sphere & a thin circular plate (all having same mass and made of same material) are all heated to 300Â°C and allowed to cool in natural air. Which one will cool the slowest ?

Discussion

No Comment Found

Related MCQs

Reply to Comment