A 3-phase, 600 V motor, the load having 0.6 power factor uses two watt-meter to measure the power. If the power measured be 45 kW, then the reading of each instrument will be?

A 3-phase, 600 V motor, the load having 0.6 power factor uses two watt

1.	A 3-phase, 600 V motor, the load having 0.6 power factor uses two watt-meter to measure the power. If the power measured be 45 kW, then the reading of each instrument will be?
A.	P<sub>1</sub> = 35 kW, P<sub>2</sub> = 10 kW
B.	P<sub>1</sub> = 47.25 kW, P<sub>2</sub> = -2.25 kW
C.	P<sub>1</sub> = 39.82 kW, P<sub>2</sub> = 5.179 kW
D.	P<sub>1</sub> = 45 kW, P<sub>2</sub> = 0 kW
Answer» D. P<sub>1</sub> = 45 kW, P<sub>2</sub> = 0 kW

Discussion

No Comment Found

Related MCQs

Two watt-meters connected to measure the total power on a three-phase system supplying a balanced load reads 10.5 kW and -2.5 kW respectively. Then the total power factor is?
In the Two wattmeter method of measuring power in a balanced three-phase circuit, one wattmeter shows zero and the other positive maximum. The load power factor is?
An average-reading digital Multimeter reads 10 V when fed with a triangular wave, symmetric about the time-axis. If the input is same, the rms reading meter will read?
A 3-phase, 600 V motor, the load having 0.6 power factor uses two watt-meter to measure the power. If the power measured be 45 kW, then the reading of each instrument will be?
The meter constant of a single-phase, 100 V induction watt-meter is 600 rev/kW-h. The speed of the meter disc for a current of 15 A at 0.8 power factor lagging will be?
The line to line input voltage to the 3-phase, 50 Hz, AC circuit, is 100 V rms. Assuming that the phase sequence is RYB; the watt-meters would read?
A sampling watt-meter is used to measure the average power of a load. The peak to peak voltage of the square wave is 10 V and the current is a triangular wave of 5A p-p. The reading in watt will be?
A circuit is used to measure the power consumed by the load. The current coil and the voltage coil of the watt-meter have 0.02 and 1000 resistances respectively. The measured power (as compared to the load power) will be?
Two watt-meters, which are connected to measure the total power on a three-phase system supplying a balanced load, read 20.5 kW and -3.5 kW respectively. The total power is?
A coil (which can be modelled as a series RL circuit) has been designed for high Q performance. The voltage is rated at and a specified frequency. If the frequency of operation is increased 10 times and the coil is operated at the same rated voltage. The new value of Q factor and the active power P will be?

A 3-phase, 600 V motor, the load having 0.6 power factor uses two watt-meter to measure the power. If the power measured be 45 kW, then the reading of each instrument will be?

Discussion

No Comment Found

Related MCQs

Reply to Comment