Explore topic-wise MCQs in Engineering Metrology.

This section includes 5 Mcqs, each offering curated multiple-choice questions to sharpen your Engineering Metrology knowledge and support exam preparation. Choose a topic below to get started.

1.

What is the hole size which is covered by IT05?

A. 500 mm
B. 600 mm
C. 700 mm
D. 800 mm
Answer» B. 600 mm
Discussion
2.

For tolerance grades 5 to 16, what is the formula for standard tolerance factor?
(D=mean diameter in mm)

A. 0.45 (D)<sup>1/3</sup> + 0.001D
B. 10*D
C. 0.45 (D)<sup>3</sup> + 0.001 D
D. 20*D
Answer» B. 10*D
Discussion
3.

What is IT01 ?

A. Basic size of hole
B. Basic size of shaft
C. Tolerance grade
D. Standard tolerance factor
Answer» D. Standard tolerance factor
Discussion
4.

What is Go limit ?

A. Lower limit of shaft and upper limit of hole
B. Lower limit of shaft and hole
C. Upper limit of shaft and lower limit of a hole
D. Upper limit of shaft and hole
Answer» D. Upper limit of shaft and hole
Discussion
5.

What does 50 represents in 50H8/g7?

A. Basic size
B. Actual size
C. Maximum limit of size
D. Minimum limit of size
Answer» B. Actual size
Discussion