MCQOPTIONS
Saved Bookmarks
MCQOPTIONS
This section includes 3 Mcqs, each offering curated multiple-choice questions to sharpen your Engineering Metrology knowledge and support exam preparation. Choose a topic below to get started.
| 1. |
Which of the following is a criterion of a good bearing surface? |
| A. | Positive skew |
| B. | Negative skew |
| C. | Negative peak roughness |
| D. | Positive start up length |
| Answer» C. Negative peak roughness | |
| 2. |
What is ten point height of irregularities? |
| A. | Average difference between 10 highest peaks |
| B. | Average difference between 10 deepest valleys |
| C. | Average difference between 5 highest peaks and 5 deepest valleys |
| D. | Average difference between 10 highest peaks and 10 deepest valleys |
| Answer» D. Average difference between 10 highest peaks and 10 deepest valleys | |
| 3. |
What do you mean by Geometrical Surface? |
| A. | Surface prescribed by design without any errors of form or surface roughness |
| B. | Surface limiting the body and separating it from surrounding |
| C. | Close representation of real surface |
| D. | Outer surface of the body |
| Answer» B. Surface limiting the body and separating it from surrounding | |