MCQOPTIONS
Saved Bookmarks
MCQOPTIONS
This section includes 5 Mcqs, each offering curated multiple-choice questions to sharpen your Engineering Metrology knowledge and support exam preparation. Choose a topic below to get started.
| 1. |
What is the hole size which is covered by IT05? |
| A. | 500 mm |
| B. | 600 mm |
| C. | 700 mm |
| D. | 800 mm |
| Answer» B. 600 mm | |
| 2. |
For tolerance grades 5 to 16, what is the formula for standard tolerance factor?(D=mean diameter in mm) |
| A. | 0.45 (D)<sup>1/3</sup> + 0.001D |
| B. | 10*D |
| C. | 0.45 (D)<sup>3</sup> + 0.001 D |
| D. | 20*D |
| Answer» B. 10*D | |
| 3. |
What is IT01 ? |
| A. | Basic size of hole |
| B. | Basic size of shaft |
| C. | Tolerance grade |
| D. | Standard tolerance factor |
| Answer» D. Standard tolerance factor | |
| 4. |
What is Go limit ? |
| A. | Lower limit of shaft and upper limit of hole |
| B. | Lower limit of shaft and hole |
| C. | Upper limit of shaft and lower limit of a hole |
| D. | Upper limit of shaft and hole |
| Answer» D. Upper limit of shaft and hole | |
| 5. |
What does 50 represents in 50H8/g7? |
| A. | Basic size |
| B. | Actual size |
| C. | Maximum limit of size |
| D. | Minimum limit of size |
| Answer» B. Actual size | |