MCQOPTIONS
Saved Bookmarks
MCQOPTIONS
This section includes 3 Mcqs, each offering curated multiple-choice questions to sharpen your Design Of Steel Structures knowledge and support exam preparation. Choose a topic below to get started.
| 1. |
Which of the following is true about built up section? |
| A. | Built up members are less rigid than single rolled section |
| B. | Single rolled section are formed to meet required area which cannot be provided by built up members |
| C. | Built up members can be made sufficiently stiff |
| D. | Built up sections are not desirable when stress reversal occurs |
| Answer» D. Built up sections are not desirable when stress reversal occurs | |
| 2. |
Which among the following comparison between angle and flat bars is not true? |
| A. | for light loads, angles are preferred over flat bars |
| B. | flat bar tension members tend to vibrate during passage of load in light bridges |
| C. | flat bars are used instead of angles in case of stress reversal |
| D. | angles are used instead of flat bars in case of stress reversal |
| Answer» D. angles are used instead of flat bars in case of stress reversal | |
| 3. |
Sagging of members by built up bars and rods may be minimised by |
| A. | increasing length diameter |
| B. | increasing thickness ratio |
| C. | fabricating rod/bar short of its required theoretical length |
| D. | fabricating rod/bar more than its required theoretical length |
| Answer» D. fabricating rod/bar more than its required theoretical length | |