

MCQOPTIONS
Saved Bookmarks
This section includes 15 Mcqs, each offering curated multiple-choice questions to sharpen your Cognitive Radio knowledge and support exam preparation. Choose a topic below to get started.
1. |
Minimum shift keying experiences phase discontinuities. |
A. | True |
B. | False |
Answer» C. | |
2. |
Gaussian minimum shift keying is based on frequency shift keying. |
A. | True |
B. | False |
Answer» B. False | |
3. |
Which among the following is a simple expression of throughput objective? |
A. | R<sub>th</sub>=kR<sub>s</sub> where R<sub>s</sub> is symbol rate |
B. | R<sub>th</sub>=kR<sub>b</sub> where R<sub>b</sub> is bit rate |
C. | R<sub>th</sub>=R<sub>s</sub>R<sub>b</sub> where R<sub>s</sub> is symbol rate and R<sub>b</sub> is bit rate |
D. | R<sub>th</sub>=R<sub>s</sub>/R<sub>b</sub> where R<sub>s</sub> is symbol rate and R<sub>b</sub> is bit rate |
Answer» B. R<sub>th</sub>=kR<sub>b</sub> where R<sub>b</sub> is bit rate | |
4. |
Which among the following is an objective that influences throughput? |
A. | Bit error rate |
B. | Bandwidth |
C. | Spectral efficiency |
D. | Signal to interference ratio |
Answer» B. Bandwidth | |
5. |
____ is a measure of good information received. |
A. | Latency |
B. | Data rate |
C. | Bit rate |
D. | Throughput |
Answer» E. | |
6. |
Signal to interference plus noise ratio is defined as ____ |
A. | ratio of noise power to interference power |
B. | ratio of signal power to sum of noise and interference power |
C. | ratio of sum of noise and interference power to signal power |
D. | ratio of interference to noise power |
Answer» C. ratio of sum of noise and interference power to signal power | |
7. |
Signal to interference plus noise ratio gives ____ |
A. | lower bound on channel capacity |
B. | upper bound on channel capacity |
C. | upper bound on receiver capacity |
D. | lower bound on channel capacity |
Answer» C. upper bound on receiver capacity | |
8. |
The aim of interference objective is ____ |
A. | to determine compatibility of waveform and frequency |
B. | to determine compatibility of waveform and radio environment |
C. | to compare channels |
D. | to compare signals |
Answer» E. | |
9. |
The modification of a signal due to extraneous power exhibited by a signal from a nearby channel is called ____ |
A. | co-channel interference |
B. | adjacent channel interference |
C. | inter-symbol interference |
D. | inter-carrier interference |
Answer» C. inter-symbol interference | |
10. |
Which among the following is an expression for spectral efficiency? |
A. | = ( frac{R_sk}{B} ). where R<sub>s</sub> is the symbol rate, B is the bandwidth, K is the number of bits per symbol |
B. | =R<sub>sB</sub> where R<sub>s</sub> is the symbol rate, B is the bandwidth, K is the number of bits per symbol |
C. | = ( frac{Bk}{R_s} )where R<sub>s</sub> is the symbol rate, B is the bandwidth, K is the number of bits per symbol |
D. | =BK where B is the bandwidth |
Answer» B. =R<sub>sB</sub> where R<sub>s</sub> is the symbol rate, B is the bandwidth, K is the number of bits per symbol | |
11. |
The minimisation of bandwidth causes ____ |
A. | low symbol rate |
B. | high symbol rate |
C. | high power |
D. | low power |
Answer» B. high symbol rate | |
12. |
Spectral efficiency may be expressed in terms of ____ |
A. | Hertz |
B. | bits per second |
C. | Hertz per bit per second |
D. | bits per Hertz per second. |
Answer» D. bits per Hertz per second. | |
13. |
____ filter is required to form ____ filter. |
A. | Two raised cosine filter, one sinc filter |
B. | Two raised sinc filter, one raised cosine filter |
C. | Two root raised cosine filter, one raised cosine filter |
D. | Two raised cosine filter, one root raised cosine filter |
Answer» D. Two raised cosine filter, one root raised cosine filter | |
14. |
____ is used to reduce inter-symbol interference. |
A. | Root raised cosine filter |
B. | Sinc filter |
C. | Root raised sinc filter |
D. | Cosine filter |
Answer» B. Sinc filter | |
15. |
Which among the following is an objective not dependent on bandwidth? |
A. | Bit error rate |
B. | Interference power |
C. | Throughput |
D. | Power |
Answer» E. | |