

MCQOPTIONS
Saved Bookmarks
This section includes 15 Mcqs, each offering curated multiple-choice questions to sharpen your Analog Communications knowledge and support exam preparation. Choose a topic below to get started.
1. |
What will be the effect on power if the distance between the sidebands and center frequency increases? |
A. | power decreases |
B. | power increases |
C. | power remains same |
D. | power becomes twice of its previous value |
Answer» B. power increases | |
2. |
What is the full form of NBFM? |
A. | Narrow band frequency modulation |
B. | National broadcast frequency modulation |
C. | Near band frequency modulation |
D. | Non broadcast frequency modulation |
Answer» B. National broadcast frequency modulation | |
3. |
In FM system, capture effect is observed when an FM receiver switching suddenly between two stations having nearby frequencies. |
A. | True |
B. | False |
Answer» B. False | |
4. |
FM stereo _________ |
A. | is implemented using an SCA signal |
B. | has a higher signal to noise ratio than mono FM |
C. | is not compatible with mono FM |
D. | uses DSBSC AM modulation |
Answer» E. | |
5. |
Signal to noise ratio of a frequency modulated system is better than amplitude modulated system. |
A. | True |
B. | False |
Answer» B. False | |
6. |
Which statement is true about direct FM modulator? |
A. | it integrates the modulating signal |
B. | it differentiates the modulating signal |
C. | varies the frequency of carrier oscillator |
D. | varies the phase of carrier oscillator |
Answer» D. varies the phase of carrier oscillator | |
7. |
What is the full form of ALC? |
A. | Amplitude Level Control |
B. | Automatic Level Control |
C. | Automatic Limiter Control |
D. | Amplitude Limiter Control |
Answer» C. Automatic Limiter Control | |
8. |
Which statement is true about indirect FM modulator? |
A. | it integrates the modulating signal |
B. | it differentiates the modulating signal |
C. | varies the frequency of carrier oscillator |
D. | varies the phase of carrier oscillator |
Answer» E. | |
9. |
The time taken by the charge carrier to cross from the emitter to the collector is called ________ |
A. | miller time |
B. | transit time |
C. | charge time |
D. | relaxing time |
Answer» C. charge time | |
10. |
A resonant circuit is used in narrowband RF amplifiers. |
A. | True |
B. | False |
Answer» B. False | |
11. |
To generate a SSB signal ________ |
A. | Full carrier AM is required |
B. | DSB-SC is required |
C. | Quadrature signal is required |
D. | High frequency signal is needed |
Answer» C. Quadrature signal is required | |
12. |
The ability to change the operating frequency rapidly without a lot of retuning is called ________ |
A. | Agility |
B. | VCO |
C. | Mixing |
D. | Filtering |
Answer» B. VCO | |
13. |
In high level amplitude modulation, power in the sidebands comes from _________ |
A. | Modulating amplifier |
B. | RF amplifier |
C. | Driver stage |
D. | Carrier |
Answer» B. RF amplifier | |
14. |
The person who sent the first radio signal across the atlantic ocean was ________ |
A. | Marconi |
B. | Maxwell |
C. | Hertz |
D. | Bell |
Answer» B. Maxwell | |
15. |
What is the use of bypass capacitor? |
A. | to remove RF from non-RF circuits |
B. | to couple RF around an amplifier |
C. | acts as low pass filter |
D. | acts as high pass filter |
Answer» B. to couple RF around an amplifier | |