

MCQOPTIONS
Saved Bookmarks
This section includes 14 Mcqs, each offering curated multiple-choice questions to sharpen your Irrigation Engineering knowledge and support exam preparation. Choose a topic below to get started.
1. |
A siphon spillway in a concrete gravity dam is in the shape of ________________ |
A. | U-shape |
B. | Inverted U-shape |
C. | Horizontal bend through the abutment |
D. | Any straight line |
Answer» C. Horizontal bend through the abutment | |
2. |
For a saddle siphon, the maximum operative head is 4.53 m. The width and height of the throat of the siphon are 5 m and 2.25 m respectively. The coefficient of discharge is 0.90. How many units are required to pass a flood of 350 cumecs? (Assume g = 10 m/s2) |
A. | One |
B. | Two |
C. | Three |
D. | Four |
Answer» E. | |
3. |
Morning glory is the _____________________________ |
A. | special flared inlet of the shaft spillway of a dam of very small height |
B. | special flared inlet of the shaft spillway of a large dam project |
C. | a horizontal tunnel constructed in a shaft spillway across the body of a gravity dam to carry surplus reservoir water to the d/s river |
D. | a horizontal tunnel constructed in a shaft spillway of an earthen dam through its foundation to carry surplus reservoir water to the d/s river |
Answer» C. a horizontal tunnel constructed in a shaft spillway across the body of a gravity dam to carry surplus reservoir water to the d/s river | |
4. |
The structure which is not used in a shaft spillway is ________________ |
A. | tunnel |
B. | bridge |
C. | radial gates |
D. | radial piers |
Answer» D. radial piers | |
5. |
The allowable maximum negative head on an average is equal to __________ |
A. | 2.5 m or so |
B. | 5 m or so |
C. | 7.5 m or so |
D. | 10 m or so |
Answer» D. 10 m or so | |
6. |
A siphon spillway is sufficiently independent of the water surface elevation of the reservoir. |
A. | True |
B. | False |
Answer» B. False | |
7. |
The crest of a siphon spillway is fixed at ________________ |
A. | full reservoir level |
B. | dead storage level |
C. | maximum water level |
D. | top of the dam |
Answer» B. dead storage level | |
8. |
Which of the following spillway is designed in India by Ganesh Iyer? |
A. | Saddle siphon spillway |
B. | Saddle spillway |
C. | Glory hole spillway |
D. | Volute Siphon spillway |
Answer» E. | |
9. |
An air vent is provided at FRL to break the siphoning action at that level in a ___________________ |
A. | hooded type of siphon spillway |
B. | tilted outlet type of siphon spillway |
C. | saddle siphon spillway |
D. | volute siphon spillway |
Answer» D. volute siphon spillway | |
10. |
The only spillway among the following through which the discharge is almost at its capacity rate even from the start of its functioning is ________________ |
A. | chute spillway |
B. | side-channel spillway |
C. | ogee spillway |
D. | siphon spillway |
Answer» E. | |
11. |
The only spillway among the following through which the discharge does not increase as fast as it increases in all others is _________________ |
A. | chute spillway |
B. | side-channel spillway |
C. | ogee spillway |
D. | shaft spillway |
Answer» E. | |
12. |
The siphons installed over overflow dams constitute what are known as __________________ |
A. | hooded type siphon spillway |
B. | tilted outlet type siphon spillway |
C. | discharge carriers |
D. | baby siphons |
Answer» B. tilted outlet type siphon spillway | |
13. |
The siphons installed within a gravity dam to spill the surplus reservoir water are known as ______________________ |
A. | hooded type siphon spillway |
B. | tilted outlet type siphon spillway |
C. | both hooded and titled type siphon spillway |
D. | shaft spillway |
Answer» C. both hooded and titled type siphon spillway | |
14. |
A shaft spillway is located _______________________ |
A. | inside the body of a gravity dam |
B. | inside the upstream reservoir |
C. | inside the downstream reservoir |
D. | on the side flanks of the main dam |
Answer» C. inside the downstream reservoir | |