Explore topic-wise MCQs in Electronics.

This section includes 32 Mcqs, each offering curated multiple-choice questions to sharpen your Electronics knowledge and support exam preparation. Choose a topic below to get started.

1.

The access time (t) of a memory IC is governed by the IC's:

A. internal address buffer
B. internal address decoder
C. volatility
D. internal address decoder and volatility
Answer» C. volatility
2.

To reduce the number of pins on the IC package, manufacturers often use ___________.

A. MOSFET architecture
B. address multiplexing
C. address decoding
D. address demultiplexing
Answer» C. address decoding
3.

Storage density is a term used to compare the memory storage ability of one device to that of another.

A. 1
B.
Answer» B.
4.

The periodic recharging of DRAM memory cells is called ___________.

A. multiplexing
B. bootstrapping
C. refreshing
D. flashing
Answer» D. flashing
5.

A memory map is an address-listing diagram that shows the boundaries of the address space.

A. 1
B.
Answer» B.
6.

The process of entering data into the ROM is called ___________.

A. burning in
B. configuration
C. internal decoding
D. addressing
Answer» B. configuration
7.

The number that is a unique representation of the location of data is its address.

A. 1
B.
Answer» B.
8.

________ is an example of read/write memory.

A. PROM
B. EEPROM
C. RAM
D. MROM
Answer» D. MROM
9.

PROMs are volatile.

A. 1
B.
Answer» C.
10.

Select the best description of the fusible-link PROM.

A. user programmable, one-time programmable
B. manufacturer programmable, one-time programmable
C. user programmable, reprogrammable
D. manufacturer programmable, reprogrammable
Answer» B. manufacturer programmable, one-time programmable
11.

The data stored in a Mask ROM (MROM) is ___________.

A. permanent
B. volatile
C. erasable
D. temporary
Answer» B. volatile
12.

Memory configuration refers to the organization of storage bits within a memory.

A. 1
B.
Answer» B.
13.

A technique of addressing storage cells on a dynamic RAM that sequentially uses the same inputs for the row and column addresses of the cell is called________.

A. flash conversion
B. dynamic refresh
C. address multiplexing
D. address strobe
Answer» D. address strobe
14.

ROM stands for read-only memory.

A. 1
B.
Answer» B.
15.

In general, _________ are used when a small amount of read/write is required.

A. EEPROMs
B. PROMs
C. SRAMs
D. DRAMs
Answer» D. DRAMs
16.

To avoid data loss, SRAM must be refreshed every few milliseconds.

A. 1
B.
Answer» C.
17.

The time interval between the memory receiving a new address input and the data being available is called _________.

A. access time
B. bus speed
C. read/write speed
D. write/data speed
Answer» B. bus speed
18.

Which of the following RAM timing parameters determine(s) its operating speed?

A. tacc
B. taa and tacs
C. t1 and t3
D. trc and twc
Answer» D. trc and twc
19.

Advantage(s) of an EEPROM over an EPROM is (are):

A. the EPROM can be erased with ultraviolet light in much less time than an EEPROM
B. the EEPROM can be erased and reprogrammed without removal from the circuit
C. the EEPROM has the ability to erase and reprogram individual words
D. the EEPROM can erase and reprogram individual words without removal from the circuit
Answer» E.
20.

When a binary word is stored in a memory location of a ROM, the process is called burning in.

A. 1
B.
C. 1
D.
Answer» B.
21.

Refreshing DRAM typically must occur every ________.

A. 2 s
B. 2 ms
C. 8 s
D. 8 ms
Answer» C. 8 s
22.

The key advantage of the EPROM is its ability to erase only a single byte of stored data.

A. 1
B.
Answer» C.
23.

Memory that loses its contents when power is lost is:

A. nonvolatile
B. volatile
C. random
D. static
Answer» C. random
24.

An SRAM storage cell is less complex than a DRAM storage cell.

A. 1
B.
C. 1
D.
Answer» C. 1
25.

Which of the following best describes nonvolatile memory?

A. memory that retains stored information when electrical power is removed
B. memory that loses stored information when electrical power is removed
C. magnetic memory
D. nonmagnetic memory
Answer» B. memory that loses stored information when electrical power is removed
26.

How many storage locations are available when a memory device has twelve address lines?

A. 144
B. 512
C. 2048
D. 4096
Answer» E.
27.

Which of the following memories uses a MOSFET and a capacitor as its memory cell?

A. SRAM
B. DRAM
C. ROM
D. DROM
Answer» C. ROM
28.

A nonvolatile type of memory that can be programmed and erased in sectors, rather than one byte at a time is:

A. flash memory
B. EPROM
C. EEPROM
D. MPROM
Answer» B. EPROM
29.

The binary data stored in an EEPROM is___________.

A. volatile
B. permanent
C. refreshed
D. erasable
Answer» E.
30.

Select the best description of read-only memory (ROM).

A. nonvolatile, used to store information that changes during system operation
B. nonvolatile, used to store information that does not change during system operation
C. volatile, used to store information that changes during system operation
D. volatile, used to store information that does not change during system operation
Answer» C. volatile, used to store information that changes during system operation
31.

The access time (tacc) of a memory IC is governed by the IC's:

A. internal address buffer
B. internal address decoder
C. volatility
D. internal address decoder and volatility
Answer» C. volatility
32.

A computerized self-diagnostic for a ROM test uses:

A. the check-sum method
B. a ROM listing
C. ROM comparisons
D. a checkerboard test
Answer» B. a ROM listing