Explore topic-wise MCQs in Geotechnical Engineering.

This section includes 130 Mcqs, each offering curated multiple-choice questions to sharpen your Geotechnical Engineering knowledge and support exam preparation. Choose a topic below to get started.

51.

The critical hydraulic gradient ic in terms of specific gravity G and voids ratio e is given by ______

A. Ge
B. G/e
C. \(\frac{G-1}{1+e}\)
D. \(\frac{G+1}{1-e}\)
Answer» D. \(\frac{G+1}{1-e}\)
52.

Khosla’s theory can be used for calculating which of the following?

A. Uplift pressure and exit gradient
B. Seepage pressure
C. None of the mentioned
D. All of the mentioned
Answer» B. Seepage pressure
53.

The coefficient of permeability is 6*10¯⁷cm/s for a soil with a certain liquid. If the viscosity is reduced to half, then the coefficient of permeability is __________

A. 6*10¯⁷cm/s
B. 17*10¯⁷cm/s
C. 8*10¯⁷cm/s
D. 12*10¯⁷cm/s
Answer» E.
54.

The phreatic line is also known as the ________

A. seepage line
B. discharge line
C. velocity line
D. pressure line
Answer» B. discharge line
55.

The pressure at the exit gradient at which the upward force is equal to the submerged weight of the soil is called the ___________

A. Floatation gradient
B. Bursting gradient
C. Critical gradient
D. All of the mentioned
Answer» E.
56.

Water is flowing at a rate of 0.04 m³/s in a soil sample of 12m thick and cross section of 50m². The coefficient of permeability is 1.6*10¯³m/s. What will be the seepage pressure?

A. 50.76 kN/m²
B. 52.34 kN/m²
C. 55.34 kN/m²
D. 58.86 kN/m²
Answer» E.
57.

In the zone of soil through which water seeps, there will be ____________ change in the degree of saturation.

A. More
B. Less
C. All of the mentioned
D. None of the mentioned
Answer» E.
58.

The critical hydraulic gradient ic is unity when the specific gravity G=2.67 and voids ratio e is ______

A. 0.67
B. 0.33
C. 0.43
D. 0.80
Answer» B. 0.33
59.

The hydraulic gradient theory of weir design was developed by __________

A. Darcy and Beresford
B. Col. Clibborn
C. None of the mentioned
D. All of the mentioned
Answer» B. Col. Clibborn
60.

In the earth dam with no filter, the base parabola does not cut the d/s slope.

A. True
B. False
C. May be True or False
D. Can't say
Answer» C. May be True or False
61.

If the effective permeability k’ is 6*10¯⁷cm/s and kᵧ=4*10¯⁷cm/s, then kₓ is equal to ________

A. 6*10¯⁷cm/s
B. 7*10¯⁷cm/s
C. 8*10¯⁷cm/s
D. 9*10¯⁷cm/s
Answer» E.
62.

What is the line within a dam section, below which there are positive hydrostatic pressures?

A. Phreatic and Seepage line
B. Equipotential line
C. None of the mentioned
D. All of the mentioned
Answer» B. Equipotential line
63.

The total head at any point may be regarded as _________ measure with respect to the datum.

A. potential energy
B. potential energy per unit weight of water
C. unit weight of water
D. volume of water
Answer» C. unit weight of water
64.

The hydraulic potential at any point is given by _________

A. h=hw±Z
B. h=hw*Z
C. h=hw/Z
D. h=Z/hw
Answer» B. h=hw*Z
65.

Seepage pressure is responsible for quick sand condition.

A. True
B. False
C. May be True or False
D. Can't say
Answer» B. False
66.

The critical hydraulic gradient is given by _______

A. ic = γ’/ γw
B. ic = γ’+ γw
C. ic = γ’-γw
D. ic = γ’
Answer» B. ic = γ’+ γw
67.

The seepage pressure pₛ with respect to hydraulic gradient i is given by ________

A. ihγwz
B. iγwz/h
C. iγwz
D. ih/zγw
Answer» D. ih/zγw
68.

The relationship between seepage force J and seepage pressure pₛ is given by _______

A. J=pₛ/A
B. J=pₛ+A
C. J=pₛ–A
D. J=pₛA
Answer» E.
69.

The effective pressure subjected to seepage pressure is given by _______

A. σ’=zγsat*izγw
B. σ’=zγ’*izγw
C. σ’=zγ’±izγw
D. σ’=zγ’/izγw
Answer» D. σ’=zγ’/izγw
70.

The deflection of flow lines at interface of dissimilar soils is given by ______

A. \(\frac{k_1}{k_2} =cosθ\)
B. \(\frac{k_1}{k_2} =sinθ \)
C. \(\frac{k_1}{k_2} =\frac{tanθ_1}{tanθ_2} \)
D. \(\frac{k_1}{k_2} =cotθ\)
Answer» D. \(\frac{k_1}{k_2} =cotθ\)
71.

Total head is the sum of ________

A. piezometric head and velocity head
B. piezometric head and position head
C. position head and velocity head
D. velocity head and pressure head
Answer» C. position head and velocity head
72.

The phreatic line can be located by Casagrande method.

A. True
B. False
C. May be True or False
D. Can't say
Answer» B. False
73.

The seepage medium can be replaced by ____________electric model having the same geometric shape.

A. Potential divider
B. Insulator
C. Electric conductor
D. Potentiometer
Answer» D. Potentiometer
74.

A hydraulic structure should not be built on pervious soil, because of _________

A. Higher water level at the upstream of the structure
B. Compressibility of the soil is low
C. Excessive water pressure above the soil
D. None of the mentioned
Answer» B. Compressibility of the soil is low
75.

In ______ direction of flow, the effective pressure is increased.

A. perpendicular
B. tangential
C. upward
D. downward
Answer» E.
76.

The seepage pressure pₛ is given by _________

A. hγw
B. h/γw
C. h+γw
D. h-γw
Answer» B. h/γw
77.

The concept of undermining by ‘foundation’ was put forward by ____________

A. F.F.Haigh
B. Khosla
C. Casagrande
D. Pavlov sky
Answer» B. Khosla
78.

Calculate the height of water table rise in soil mass from a sand stratum of 12m deep from ground level, at which the effective pressure is zero. The water percolates through a soil mass of thickness 5m. The γsat=18.6 kN/m³ and γw=9.81 kN/m³.

A. 7.68m
B. 9.48m
C. 5.24m
D. 10m
Answer» C. 5.24m
79.

The first rational approach to the problem of seepage through soils was ________

A. Archimedes
B. Poiseuille
C. Darcy
D. Terzaghi
Answer» E.
80.

The seepage force per unit volume j is given by _______

A. j=iγwzA
B. j=izA
C. j=iγw
D. j=zA
Answer» D. j=zA
81.

The exit gradient can be expressed by which of the following expression?

A. ie = Δh/i
B. ie = Δh.i
C. ie = l/h
D. ie = h/i
Answer» B. ie = Δh.i
82.

Undermining of the sub soil is due to ___________

A. Seepage
B. Piping
C. Excessive water pressure
D. Uplift pressure
Answer» E.
83.

The flow lines and equipotential proposed by Kozney is in the shape of ____________

A. Hyperbola
B. Ellipse
C. Parabola
D. Circle
Answer» D. Circle
84.

The quantity of water which flows out from any element of volume is _________ than quantity which flows out.

A. Greater
B. smaller
C. Equal
D. All of the mentioned
Answer» D. All of the mentioned
85.

Water is flowing at a rate of 0.04 m³/s in a soil sample of 12m thick and cross section of 50m². The coefficient of permeability is 1.6*10¯³m/s. What will be the seepage force?

A. 2943kN
B. 3453kN
C. 2454kN
D. 2443kN
Answer» B. 3453kN
86.

The seepage pressure always acts _______

A. in the direction of flow
B. opposite to direction of flow
C. perpendicular to direction of flow
D. tangential to direction of flow
Answer» B. opposite to direction of flow
87.

The position head is also called ________

A. total head
B. elevation head
C. velocity head
D. pressure head
Answer» C. velocity head
88.

The path along which, the individual particles of water seep through the soil are ___________

A. Stream lines and Flow lines
B. Equipotential lines
C. None of the mentioned
D. All of the mentioned
Answer» B. Equipotential lines
89.

The hydrostatic pressure in terms of piezometric head can be calculated from which of the following equation?

A. hW = h – Z
B. hW = h + Z
C. hW = u/γW
D. hW = h/z
Answer» B. hW = h + Z
90.

The hydraulic gradient is equal to the __________

A. hydraulic head
B. velocity head
C. hydraulic head per unit distance
D. pressure head
Answer» D. pressure head
91.

What are the types of flow head that exist at any point in a saturated soil mass?

A. Piezometric head or pressure head
B. Velocity head
C. Position head
D. All of the mentioned
Answer» E.
92.

The slope of discharge face can exceed _______

A. 30°
B. 45°
C. 60°
D. 90°
Answer» E.
93.

In homogeneous soil, every transition in the shape of curves drawn in flow net must be ____________

A. Smooth
B. Sharp
C. Rough
D. All of the mentioned
Answer» B. Sharp
94.

The phreatic line is defined as the line within a dam section below which there are ________ in dam.

A. positive hydrostatic pressures
B. negative hydrostatic pressures
C. neutral hydrostatic pressures
D. no hydrostatic pressure
Answer» B. negative hydrostatic pressures
95.

Seepage pressure is important for which of the following purpose?

A. Stability analysis
B. Structral arrangement
C. Total head
D. All of the mentioned
Answer» B. Structral arrangement
96.

The total head at any point on soil may be regarded as __________ per unit weight of water measured.

A. Velocity energy
B. Hydraulic potential
C. Potential energy
D. Piezometric energy
Answer» C. Potential energy
97.

A combination of velocity potential (φ) and stream function (ψ) is called ___________

A. Velocity potential
B. Seepage pressure
C. Complex potential
D. Hydraulic gradient
Answer» D. Hydraulic gradient
98.

The loss of head per unit distance in soil is called ___________

A. Velocity potential
B. Hydraulic gradient
C. Velocity gradient
D. Stream function
Answer» C. Velocity gradient
99.

The quick condition takes place when effective pressure is _______

A. σ’=0
B. σ’=1
C. σ’= zγ’+ pₛ
D. σ’= zγ’
Answer» B. σ’=1
100.

A soil has voids ratio of 0.78 and critical gradient at which quick sand condition occurs is 0.94. Calculate the specific gravity.

A. 2
B. 2.5
C. 2.67
D. 2.71
Answer» D. 2.71