Explore topic-wise MCQs in Testing Subject.

This section includes 657 Mcqs, each offering curated multiple-choice questions to sharpen your Testing Subject knowledge and support exam preparation. Choose a topic below to get started.

1.

The coking process normally mostly used in Indian oil refineries is the ____________________ coking process ?

A. Delayed
B. Flexi
C. Fluid
D. Contact
Answer» B. Flexi
2.

The characterisation factor of a crude oil is calculated as 12.5. It means that; it is________________?

A. Paraffinic
B. Naphthenic
C. Intermediate
D. None of these
Answer» B. Naphthenic
3.

The characterisation factor of crude petroleum oil is around__________________?

A. 3
B. 11
C. 22
D. 28
Answer» C. 22
4.

The catalytic cracking of heavier petroleum fraction is done to produce mainly____________________?

A. Gasoline
B. Asphalt
C. Diesel oil
D. Tar
Answer» D. Tar
5.

The best method of determining sulphur in crude oil is by the _______________ method?

A. Kjeldahl
B. Dumas
C. Bomb calorimeter
D. Junkers calorimeter
Answer» D. Junkers calorimeter
6.

The average boiling point of aviation turbine fuel is closest to that of__________________?

A. Lubricating oils
B. LPG
C. Diesel
D. Kerosene
Answer» E.
7.

The amount of tetraethyl lead added to improve the octane number of motor gasoline is around ______________ c.c per gallon of petrol?

A. 3
B. 300
C. 3000
D. 1000
Answer» B. 300
8.

Salt content (measured as sodium chloride) in electrically desalted crude oil comes down to a level of about __________________ ptb (pounds per thousand barrel) ?

A. 0.03
B. 3
C. 35
D. 70
Answer» C. 35
9.

Road grade bitumen is produced from vacuum residue by its ____________________?

A. Aeration
B. Pyrolysis
C. Hydrogenation
D. Steam reforming
Answer» E.
10.

Research octane number refers to the___________________?

A. Low octane number motor fuels
B. High octane number motor fuels
C. High octane number aviation fuels
D. Unleaded motor fuels
Answer» E.
11.

Removal of light fractions from crude oil is called its _____________________?

A. Sweetening
B. Dehydration
C. Stabilisation
D. Visbreaking
Answer» D. Visbreaking
12.

Reid vapour pressure of gasoline is the measure of its_________________?

A. Pour point
B. Cloud point
C. Vapour locking tendency
D. Carbon residue
Answer» D. Carbon residue
13.

Refractive index of a petrofuel which is the ratio of velocity of light in air to its velocity in the petrofuel gives an indication if its_________________?

A. Molecular weight
B. Aromatics content
C. Both A. & B.
D. Neither ‘a’ nor ‘b’
Answer» D. Neither ‘a’ nor ‘b’
14.

Reforming__________________?

A. Uses naphtha as feedstock
B. Does not much affect the molecular weight of the feed
C. Improves the quality & yield of gasoline
D. All A., B. and C.
Answer» E.
15.

Reforming converts_________________?

A. Olefins into paraffins
B. Naphthenes into aromatics
C. Naphthenes into olefins
D. Naphthenes into paraffin
Answer» C. Naphthenes into olefins
16.

Raw Kerosene has a smoke point of 15 mm. After it is subjected to dearomatization by liquid SO2 extraction (Edeleanu process), its smoke point may become _______________________ mm?

A. 5
B. 10
C. 25
D. 100
Answer» D. 100
17.

Quinoline is a/an ________________ compound ?

A. Sulphur
B. Nitrogen
C. Oxygen
D. None of these
Answer» C. Oxygen
18.

Pyrolysis of kerosene or natural gasoline is done to produce mainly the___________________?

A. Olefins and aromatics
B. Lighter paraffins
C. Stabilised gasoline
D. Diesel
Answer» B. Lighter paraffins
19.

Products drawn from the top to bottom of the crude oil distillation column has progressively increasing ___________________?

A. Boiling points
B. Molecular weight
C. C/H ratio
D. All A., B. and C.
Answer» E.
20.

Pressure & temperature maintained in catalytic cracking is about__________________?

A. 2 atm & 500°C
B. 10 atm & 500°C
C. 30 atm & 200°C
D. 50 atm & 750°C
Answer» B. 10 atm & 500°C
21.

Pressure maintained in the high pressure primary tower of a three stage crude oil distillation system is about ______________ kg/cm2?

A. 1.5
B. 3
C. 6
D. 12
Answer» C. 6
22.

Presence of sulphur in gasoline___________________?

A. Leads to corrosion
B. Increases lead susceptibility
C. Decreases gum formation
D. Helps during stabilisation
Answer» B. Increases lead susceptibility
23.

Presence of predominantly large quantity of aromatics (polynuclear) is not desirable in aviation fuel, because it has__________________?

A. High pour point and low smoke point
B. Low viscosity index
C. High self-ignition temperature
D. All A., B. and C.
Answer» C. High self-ignition temperature
24.

Presence of aromatics in __________________?

A. Diesel increases its cetane number
B. Kerosene increases its smoke point
C. Petrol increases its octane number
D. All A., B. and C.
Answer» D. All A., B. and C.
25.

Preheating temperature of medium viscosity furnace oil for better atomisation through burner is about _______________ °C ?

A. 50
B. 70
C. 90
D. 140
Answer» D. 140
26.

Pour point of a petrofuel is________________?

A. Multiple of 3°F
B. Multiple of 5°F
C. 5°C below the temperature at which oil ceases to flow
D. None of these
Answer» D. None of these
27.

Pour point and freezing point is equal for__________________?

A. Petrol
B. Diesel
C. Water
D. Crude petroleum
Answer» D. Crude petroleum
28.

Polymerisation__________________?

A. Produces i-octane from cracked gases containing i-butane and butene
B. Causes olefins to combine with each other
C. Causes aromatics to combine with each other
D. Is aimed at producing lubricating oil
Answer» C. Causes aromatics to combine with each other
29.

Platforming is a ____________ process?

A. Moving bed
B. Fluidised bed
C. Non-regenerative & fixed bed
D. Regenerative
Answer» D. Regenerative
30.

Pick out the wrong statement about the smoking tendency of various hydrocarbon constituents of kerosene ?

A. Smoking tendency of hydrocarbons increases in the order: paraffins → isoparaffins → naphthenes → aromatics
B. Smoking tendency of paraffins increases with decrease in its molecular weight
C. Smoking tendency of naphthenes decreases with its increasing molecular weight & also on addition of double bond
D. Smoking tendency of aromatics decreases with increase in its molecular weight
Answer» C. Smoking tendency of naphthenes decreases with its increasing molecular weight & also on addition of double bond
31.

Pick out the undesirable property for a solvent meant for dewaxing of lube oil ?

A. Complete miscibility with oil
B. High solubility of wax in the solvent
C. Both A. and B.
D. Neither A. nor B.
Answer» D. Neither A. nor B.
32.

Pick out the correct statement pertaining to catalytic cracking ?

A. With increase in the reactor pressure, octane number of gasoline decreases
B. With increase in the reactor temperature, gasoline yield decreases for a given conversion
C. Percentage conversion increases with increase in the catalyst to oil ratio
D. All A., B. and C.
Answer» E.
33.

Pick out the correct statement about catalytic polymerisation ?

A. H2SO4 polymerisation process gives gasoline rich in unsaturates
B. In H2SO4 polymerisation, H3PO4 is always used with 2% steam to prevent meta & ortho H3PO4 formation, which are inactive
C. Both A. and B.
D. Neither A. nor B.
Answer» C. Both A. and B.
34.

Pick out the additive property of lube oil out of following ?

A. °API gravity
B. Specific gravity
C. Viscosity
D. Flashpoint
Answer» B. Specific gravity
35.

Phenols are added in gasoline to____________________?

A. Improve the octane number
B. Act as an antioxidant
C. Reduce its viscosity
D. Increase its pour point
Answer» C. Reduce its viscosity
36.

Petroleum ________________ ?

A. Is optically active
B. Constitutes mainly of olefins
C. Does not contain asphalt
D. Does not contain aromatics
Answer» B. Constitutes mainly of olefins
37.

Petroleum coke is used mainly in the __________________ ?

A. Discoloration of yellow glycerine
B. Sugar refining
C. Manufacture of carbon electrode
D. Blast furnace for reduction of iron ore
Answer» D. Blast furnace for reduction of iron ore
38.

Petroleum is believed to have originated from _______________ sources?

A. Vegetable
B. Animal
C. Both A. and B.
D. Neither A. nor B.
Answer» D. Neither A. nor B.
39.

Petrolatum is__________________?

A. Same as petroleum ether
B. Petroleum coke
C. A mixture of microcrystalline wax in viscous hydrocarbon liquids
D. None of these
Answer» D. None of these
40.

Performance number of a liquid fuel is related to its __________________?

A. Wax content
B. Spontaneous ignition temperature
C. Knocking tendency
D. Sulphur content
Answer» C. Knocking tendency
41.

Percentage of straight run gasoline in a typical crude oil may be around________________?

A. 6
B. 18
C. 38
D. 52
Answer» E.
42.

Penetration test determines the _____________ of the grease?

A. Stiffness
B. Lubricating properties (e.g. oilness)
C. Service temperature
D. Variation in viscosity with temperature
Answer» B. Lubricating properties (e.g. oilness)
43.

Paraffins are desirable in lubricating oil, as it has got high_____________________?

A. Viscosity
B. Viscosity index
C. Smoke point
D. Pour point
Answer» D. Pour point
44.

Paraffin base crude oil as compared to asphalt base crude gives___________________?

A. Higher yield of straight run gasoline
B. Higher octane number gasoline
C. Lower viscosity index lube oil
D. Poorer yield of lube oil
Answer» B. Higher octane number gasoline
45.

Operating temperature and pressure in catalytic reforming is about_____________?

A. 1-5 Kgf/cm2 & 200°C
B. 15-45 Kgf/cm2 & 450-550°C
C. 50 – 75 kgf/cm2 & 600 – 800°C
D. 5-10 kgf/cm2 & 150 – 250°C
Answer» C. 50 – 75 kgf/cm2 & 600 – 800°C
46.

Operating condition in the electrical dehydrators for crude oil is about____________________?

A. 6.5 kgf/Cm2 & 95°C
B. 1 atm. & 110 °C
C. 20 kgf/cm2 & 110°C
D. 50 atm. and 150°C
Answer» B. 1 atm. & 110 °C
47.

Olefins are_________________?

A. Saturated hydrocarbons
B. Unsaturated cyclic compounds (hydrocarbons)
C. Present in substantially good quantity in crude petroleum
D. None of these
Answer» E.
48.

Older crude petroleum __________________?

A. Is light and better
B. Gives more distillates
C. Gives less tar
D. All A., B. and C.
Answer» C. Gives less tar
49.

Octane number (unleaded) of gasoline produced by isomerisation of butane may be about __________________?

A. 45
B. 55
C. 70
D. 90
Answer» D. 90
50.

Octane numbers of motor gasoline used in India and America are respectively________________?

A. 87 & 94
B. 94 & 87
C. 94 & 100
D. 83 & 100
Answer» B. 94 & 87