MCQOPTIONS
Saved Bookmarks
This section includes 13 Mcqs, each offering curated multiple-choice questions to sharpen your Automotive Engine Auxiliary Systems knowledge and support exam preparation. Choose a topic below to get started.
| 1. |
During which of the following the mixture tends to become richer in a single jet carburetor? |
| A. | During winter |
| B. | At low altitude |
| C. | At high altitude |
| D. | During idling |
| Answer» D. During idling | |
| 2. |
Inside which of the following is the lower end of the needle placed in an S U carburetor? |
| A. | Main |
| B. | Pilot |
| C. | Idling |
| D. | Compensating |
| Answer» B. Pilot | |
| 3. |
Which of the following is the main advantage of drought type carburetor? |
| A. | High volumetric efficiency |
| B. | Leakage |
| C. | Defective float |
| D. | Jet overflowing |
| Answer» B. Leakage | |
| 4. |
To adjust which of the following a jet adjusting nut in provided in an S U carburetor? |
| A. | Flow rate |
| B. | Pressure |
| C. | Mixture strength |
| D. | Enthalpy |
| Answer» D. Enthalpy | |
| 5. |
How many way valves are present in a damper plunger of an S U carburetor? |
| A. | One |
| B. | Two |
| C. | Three |
| D. | Four |
| Answer» B. Two | |
| 6. |
Where is the accelerator pedal connected in a full-throttle circuit of a carter carburetor? |
| A. | Idle port |
| B. | Metering rod |
| C. | Float |
| D. | Inlet valve |
| Answer» C. Float | |
| 7. |
Which part of the idling circuit of a carter carburetor the engine suction is applied through which air and fuel are drawn? |
| A. | Low-speed port |
| B. | Main nozzle |
| C. | Idle port |
| D. | Metering rod |
| Answer» D. Metering rod | |
| 8. |
Which of the following helps in the fuel flow when the choke is applied? |
| A. | Main jet |
| B. | Idle jet |
| C. | Transfer port |
| D. | Progression hole |
| Answer» B. Idle jet | |
| 9. |
Which among the following is provided to avoid flat spot during acceleration and delivers spurts of extra fuel in a Solex carburetor? |
| A. | Idle port |
| B. | Membrane pump |
| C. | Idle adjusting screw |
| D. | Throttle |
| Answer» C. Idle adjusting screw | |
| 10. |
Which of the following is a type of arrangement concerning Solex carburetor? |
| A. | Up- drought |
| B. | Horizontal |
| C. | Down- drought |
| D. | Both Up- droughtand Down- drought |
| Answer» D. Both Up- droughtand Down- drought | |
| 11. |
How many numbers of jets are present in a zenith type carburetor? |
| A. | 4 |
| B. | 2 |
| C. | 3 |
| D. | 1 |
| Answer» D. 1 | |
| 12. |
Which of the following is an example of constant venturi type carburetor? |
| A. | Zenith carburetor |
| B. | Carter carburetor |
| C. | S U carburetor |
| D. | Both Zenith and Carter carburetor |
| Answer» E. | |
| 13. |
Which of the following is an example of a constant vacuum type carburetor? |
| A. | Carter carburetor |
| B. | Zenith |
| C. | S U carburetor |
| D. | Both Carter and Zenith |
| Answer» D. Both Carter and Zenith | |