Explore topic-wise MCQs in Engineering Drawing.

This section includes 10 Mcqs, each offering curated multiple-choice questions to sharpen your Engineering Drawing knowledge and support exam preparation. Choose a topic below to get started.

1.

Center lines in orthographic sketches are represented by?

A. Dotted lines
B. Short and long dashed lines
C. Thin straight lines
D. Very light thick lines
Answer» C. Thin straight lines
Discussion
2.

In the orthographic views to maintain the correct proportions and orientations of the views, which of the following is the correct way to follow?

A. Draw the top, front and side views closer
B. Extend the construction lines
C. Make the blockings closer
D. Use the scale
Answer» C. Make the blockings closer
Discussion
3.

Drawing orthographic view is easier and efficient that pictorial sketching.

A. True
B. False
Answer» B. False
Discussion
4.

Arrange the following stages of drawing a circle in an orthographic sketch in an order.i. Connect all the dots with a single stroke.ii. Draw the light horizontal and vertical lines from the center of the circle.iii. Lightly mark the radius on each line

A. i, ii, iii
B. iii, ii, i
C. ii, iii, i
D. iii, i, ii
Answer» D. iii, i, ii
Discussion
5.

Sketching the three views out of six multi-views of an object can give us a general view of the object.

A. True
B. False
Answer» B. False
Discussion
6.

For improving the quality of the orthographic sketch which of the following can be used?

A. A scale
B. A compass
C. A square grid paper
D. A protractor
Answer» D. A protractor
Discussion
7.

Hidden lines in orthographic sketches are represented by?

A. Dotted lines
B. Dashed lines
C. Thin straight lines
D. Very light thick lines
Answer» C. Thin straight lines
Discussion
8.

In orthographic sketching, the center of holes is represented by _______

A. Receding construction lines
B. Thick lines
C. Construction lines
D. Dark lines
Answer» D. Dark lines
Discussion
9.

For blocking the front, top, and side views of the object, which of the following is not required?

A. Height
B. Width
C. Chamfer
D. Depth
Answer» D. Depth
Discussion
10.

How orthographic sketching is started after analyzing the object?

A. By drawing the proportionate outlines of the object
B. By blocking the front, top, and side views of the object
C. By drawing the required curves of the object
D. By detailing the object
Answer» C. By drawing the required curves of the object
Discussion