MCQOPTIONS
Saved Bookmarks
MCQOPTIONS
This section includes 14 Mcqs, each offering curated multiple-choice questions to sharpen your Machine Tools knowledge and support exam preparation. Choose a topic below to get started.
| 1. |
Right hand roughing tool is used in_______. |
| A. | lathe |
| B. | shaper |
| C. | both lathe and shaper |
| D. | none of the mentioned |
| Answer» D. none of the mentioned | |
| 2. |
Gooseneck tool is used in both lathe and shaper. |
| A. | true |
| B. | false |
| Answer» B. false | |
| 3. |
Round nose tool is used in both lathe and shaper. |
| A. | true |
| B. | false |
| Answer» B. false | |
| 4. |
Which of the following tool is not used in shaper? |
| A. | right hand finishing tool |
| B. | square nose tool |
| C. | left hand side facing tool |
| D. | none of the mentioned |
| Answer» E. | |
| 5. |
Which of the following method is not used to support the work on the table? |
| A. | clamped on the angle plate |
| B. | clamped on a V block |
| C. | held between shaper index centre |
| D. | none of the mentioned |
| Answer» E. | |
| 6. |
Which of the following method is used to support the work on the table? |
| A. | clamped in a vice |
| B. | clamped on the table |
| C. | both clamped in a vice and clamped on the table |
| D. | none of the mentioned |
| Answer» D. none of the mentioned | |
| 7. |
The bottom side of the table of a shaper has T slots for clamping the work. |
| A. | true |
| B. | false |
| Answer» C. | |
| 8. |
In shaper, tools are able to withstand shock experienced by the cutting tool at the commencement of each cutting stroke. |
| A. | true |
| B. | false |
| Answer» B. false | |
| 9. |
Shaper tools are heavy weighted. |
| A. | true |
| B. | false |
| Answer» B. false | |
| 10. |
Shaper tools are______ |
| A. | quite light |
| B. | moderate |
| C. | much more rigid |
| D. | none of the mentioned |
| Answer» D. none of the mentioned | |
| 11. |
Tool angles are same in shaper as in lathe. |
| A. | true |
| B. | false |
| Answer» C. | |
| 12. |
In a shaper, clearance is _______ to a lathe tool. |
| A. | similar |
| B. | different |
| C. | can t say anything |
| D. | none of the mentioned |
| Answer» B. different | |
| 13. |
Shaper is cutting tool having rake. |
| A. | true |
| B. | false |
| Answer» B. false | |
| 14. |
The cutting tool used in shaper is a _______ point cutting tool. |
| A. | single |
| B. | multi |
| C. | double |
| D. | none of the mentioned |
| Answer» B. multi | |