MCQOPTIONS
Saved Bookmarks
MCQOPTIONS
This section includes 10 Mcqs, each offering curated multiple-choice questions to sharpen your Engineering Drawing knowledge and support exam preparation. Choose a topic below to get started.
| 1. |
What is the use of T-squares in the manual drawing? |
| A. | To draw curves |
| B. | To draw concentric circles |
| C. | To draw horizontal and vertical lines |
| D. | To hold the sheet |
| Answer» D. To hold the sheet | |
| 2. |
In the manual drawing, which instrument is used to draw smooth curve passing through defined points? |
| A. | Drafter |
| B. | Compass |
| C. | French curve |
| D. | Drawing templates |
| Answer» D. Drawing templates | |
| 3. |
Which of the following is pencil grade is used in general for lettering and object lines? |
| A. | F |
| B. | H |
| C. | B |
| D. | 4H |
| Answer» C. B | |
| 4. |
Which of the following statements is true as per the standard metric sizes of the drawing sheet? |
| A. | A1 is double the A0 |
| B. | A3 is half the A0 |
| C. | A0 is double the A1 |
| D. | A2 is half the A3 |
| Answer» D. A2 is half the A3 | |
| 5. |
In the manual drawing, mini drafter serves the purpose of set-square, T-square, and protractor. |
| A. | True |
| B. | False |
| Answer» B. False | |
| 6. |
What is the main advantage of manual drawing over CAD? |
| A. | It can be easily stored and shared |
| B. | Accurate and effective drawings can be produced |
| C. | Take less time and need no instruments |
| D. | No need of any advancement or maintenance of high-end technology |
| Answer» E. | |
| 7. |
Which of the following states the main application of pantographs in the technical drawing? |
| A. | Holding the sheet in place |
| B. | To draw the layered structures |
| C. | To draw accurate angles without consuming much time |
| D. | Helps in drawing curved structures |
| Answer» D. Helps in drawing curved structures | |
| 8. |
As per the B.I.S recommendations, the ratio of thin and thick lines width in a drawing sheet must be __________ |
| A. | >/= 1:2 |
| B. | </= 1:2 |
| C. | >/= 1:3 |
| D. | </= 1:3 |
| Answer» B. </= 1:2 | |
| 9. |
Why do we need engineering drawing standards? |
| A. | To eliminate the originality/creativity of drafter |
| B. | To modify and organize a way of drafting |
| C. | To have effective communication of drawings |
| D. | To eliminate mistakes |
| Answer» D. To eliminate mistakes | |
| 10. |
Arrange the following statements. The given statements describe the process involved in engineering drawing.i) Sketch the initial idea and create a geometric model.ii) Exploring, understanding the problem and visualizing the idea.iii) Applying the changes document a detailed drawing.iv) Analyze, optimize and rectify the geometric model. |
| A. | i, ii, iv, iii |
| B. | ii, i, iv, iii |
| C. | iv, iii, i, ii |
| D. | i, ii, iii, iv |
| Answer» C. iv, iii, i, ii | |