MCQOPTIONS
Saved Bookmarks
MCQOPTIONS
This section includes 10 Mcqs, each offering curated multiple-choice questions to sharpen your Structural Analysis knowledge and support exam preparation. Choose a topic below to get started.
| 1. |
Live load element factor KLL remains constant for all types of structure.State whether this statement is true or false. |
| A. | True |
| B. | False |
| Answer» C. | |
| 2. |
Building codes usually permit reduction in live load when small areas are concerned.State whether this statement is true or false |
| A. | True |
| B. | False |
| Answer» C. | |
| 3. |
Live load element factor KLL remains constant for all types of structure? |
| A. | |
| B. | True |
| Answer» C. | |
| 4. |
When column supports the top floor of a building, then live load reduction is:- |
| A. | Permitted |
| B. | Not permitted |
| C. | Depends upon type of beam |
| D. | Depends upon amount of load |
| Answer» C. Depends upon type of beam | |
| 5. |
Loads used to obtain column design forces and to obtain beam design forces are:- |
| A. | Necessarily same |
| B. | Necessarily different |
| C. | Most likely same |
| D. | Most likely different |
| Answer» E. | |
| 6. |
In the case of a structural member supporting more than one floor with load exceeding 100psf., what is the maximum permitted reduction %? |
| A. | 10 |
| B. | 15 |
| C. | 20 |
| D. | 25 |
| Answer» D. 25 | |
| 7. |
What is the minimum limit of influence area (in sq. ft) till which live loads can be reduced? |
| A. | 100 |
| B. | 200 |
| C. | 300 |
| D. | 400 |
| Answer» E. | |
| 8. |
Reduction factors given in Section 4.8 of ASCE 7-02 & in Section 1607.9.1 of IBC-2003 are:- |
| A. | Different |
| B. | Same |
| C. | Vary in some cases |
| D. | There is no reduction factor in Section 4.8 of ASCE 7-02 |
| Answer» C. Vary in some cases | |
| 9. |
Building codes usually permit reduction in live load when small areas are concerned. |
| A. | |
| B. | True |
| Answer» C. | |
| 10. |
If influence area contributing to a particular load increases, then what happens to the possibility of having full design load on each square meter of area? |
| A. | Increases |
| B. | Decreases |
| C. | Doesn’t affect |
| D. | Depends on case |
| Answer» C. Doesn‚Äö√Ñ√∂‚àö√ë‚àö¬•t affect | |