MCQOPTIONS
Saved Bookmarks
MCQOPTIONS
This section includes 6 Mcqs, each offering curated multiple-choice questions to sharpen your Managing a Cisco Internetwork knowledge and support exam preparation. Choose a topic below to get started.
| 1. |
Which three commands can be used to check LAN connectivity problems on a router? 1.show interfaces 2.show ip route 3.tracert 4.ping 5.dns lookups |
| A. | 1 ,2 and 4 |
| B. | 2 and 5 |
| C. | 3 and 5 |
| D. | None of the above |
| Answer» B. 2 and 5 | |
| 2. |
ou are unsuccessful in telnetting into a remote device. What could the problem be? 1.IP addresses are incorrect. 2.Access control list is filtering Telnet. 3.There is a defective serial cable. 4.The VTY password is missing. |
| A. | 1 only |
| B. | 3 only |
| C. | 2 and 4 only |
| D. | All of the above |
| Answer» D. All of the above | |
| 3. |
You have your laptop directly connected into a router's Ethernet port. Which of the following are among the requirements for the copy flash tftp command to be successful? 1.TFTP server software must be running on the router. 2.TFTP server software must be running on your laptop. 3.The Ethernet cable connecting the laptop directly into the router's Ethernet port must be a straight-through cable. 4.The laptop must be on the same subnet as the router's Ethernet interface. 5.The copy flash tftp command must be supplied the IP address of the laptop. |
| A. | 1, 3 and 4 |
| B. | 2, 4 and 5 |
| C. | 3 and 5 only |
| D. | 5 only |
| Answer» C. 3 and 5 only | |
| 4. |
What information is displayed by the show hosts command? 1.Temporary DNS entries 2.The names of the routers created using the hostname command 3.The IP addresses of workstations allowed to access the router 4.Permanent name-to-address mappings created using the ip host command 5.The length of time a host has been connected to the router via Telnet |
| A. | 1, 2 and 3 |
| B. | 1 and 4 |
| C. | 3, 4, and 5 |
| D. | All of the above |
| Answer» C. 3, 4, and 5 | |
| 5. |
What does the command o/r 0x2142 provide? |
| A. | It is used to restart the router. |
| B. | It is used to bypass the configuration in NVRAM. |
| C. | It is used to enter ROM Monitor mode. |
| D. | It is used to view the lost password. |
| Answer» C. It is used to enter ROM Monitor mode. | |
| 6. |
You telnet into a remote device and type debug ip rip, but no output from the debug command is seen. What could the problem be? |
| A. | You must type the show ip rip command first. |
| B. | IP addressing on the network is incorrect. |
| C. | You must use the |
| D. | command. |
| E. | Debug output is sent only to the console. |
| Answer» D. command. | |