Explore topic-wise MCQs in Electronics.

This section includes 1177 Mcqs, each offering curated multiple-choice questions to sharpen your Electronics knowledge and support exam preparation. Choose a topic below to get started.

1.

Will you choose wiring for temporary works?

A. batten wiring
B. PVCConduit Wiring
C. cleat wiring
D. all of the above
Answer» D. all of the above
2.

Stranded wires are used?

A. in our head line
B. in the binding of the square
C. in binding
D. wiring in homes
Answer» B. in the binding of the square
3.

What happens in a proton?

A. negative charge
B. free of charge
C. positive charge
D. all of the above
Answer» D. all of the above
4.

The pole winding which is connected in series to the armature is called?

A. shunt field winding
B. auxiliary winding
C. damping winding
D. Interpol Winding
Answer» E.
5.

Should it be put on an electric fire?

A. acid
B. dry sand
C. Water
D. none of the above
Answer» C. Water
6.

On adding sulfuric acid to water?

A. acid changes color
B. generates excessive heat
C. water starts boiling
D. acid turns into base
Answer» D. acid turns into base
7.

What is the power factor of a pure capacitive circuit?

A. Unity
B. Zero leading
C. zero lagging
D. all of the above
Answer» D. all of the above
8.

The energy collected by the secondary cell is called?

A. electrical energy
B. chemical energy
C. heat energy
D. light energy
Answer» C. heat energy
9.

What happens in electron?

A. negative charge
B. positive charge
C. free of charge
D. all of the above
Answer» B. positive charge
10.

The property of a conductor which helps in increasing the current is called?

A. penetration
B. impedance
C. conductivity
D. above
Answer» D. above
11.

What is used as an insulator between two conductors in transmission line, distribution line and condenser?

A. dry air
B. slate
C. Bakelite
D. mica knight
Answer» C. Bakelite
12.

The area of ​​the hysteresis loop is a measure of which gun of matter?

A. magnetism
B. electromagnetism
C. energy spent per cycle
D. magnetic flux
Answer» D. magnetic flux
13.

What is a fuse wire made of?

A. lead and tin
B. copper and tin
C. of copper and zinc
D. Of zinc and tin
Answer» C. of copper and zinc
14.

Dangerous current for human body?

A. 1 mA
B. 1 A
C. 50 mA
D. 30 mA
Answer» D. 30 mA
15.

What is the unit of reluctance?

A. ampere turn
B. ampere turn./weber
C. weber
D. none of these
Answer» E.
16.

What does the arc voltage in Mercury dielectric depend on?

A. at the temperature of the arc
B. at the length of the arc
C. on the purity of mercury
D. on all of the above
Answer» C. on the purity of mercury
17.

The output of tungsten filament lamp depends on?

A. glass on the shape of a lamp
B. at the temperature of the fiber
C. on bulb size
D. on all of the above
Answer» C. on bulb size
18.

Are poles used in overhead lines?

A. pipe type poles
B. tower
C. wooden poles
D. all of the above
Answer» E.
19.

What is the distance between two poles called?

A. Spain
B. with
C. badging
D. all of the above
Answer» B. with
20.

Which of the following motors can be operated easily on the backward or forward power multiplier?

A. synchronous motor
B. cage type motor
C. slip-ring induction motor
D. all of the above
Answer» B. cage type motor
21.

The chemical used in the breather of transformer?

A. water
B. silica gel
C. Sodium chloride
D. mineral oil
Answer» C. Sodium chloride
22.

Corona loss of structure line?

A. the current exceeds
B. efficiency goes up
C. voltage drops
D. efficiency goes down
Answer» E.
23.

Power multiplier of transformer?

A. is always 0.8
B. is always the unit
C. depends on the power factor of the load
D. always backward
Answer» D. always backward
24.

By which of the following tests, transformer law regulation and efficiency without load is determined?

A. short circuit test
B. open circuit test
C. sumpner test
D. none of these
Answer» D. none of these
25.

What happens if the belt of a washing machine becomes loose?

A. Spin-tub just won't spin
B. Pulsator only won't rotate
C. the machine will come to a complete standstill
D. will have no effect on the working of the machine
Answer» C. the machine will come to a complete standstill
26.

What is the process of nuclear breakdown in a nuclear power plant called?

A. Fission
B. Fusion
C. Emission
D. all of the above
Answer» B. Fusion
27.

Which of the following heating method has the highest power factor?

A. induction heating
B. arc heating
C. dielectric heating
D. resistance heating
Answer» E.
28.

What are the relays in refrigerators?

A. By simple switch
B. non-magnetic
C. magnetic type
D. all of the above
Answer» D. all of the above
29.

Which of the following has the maximum periodicity of a frequency?

A. 10Hz
B. 100kHz
C. 100Hz
D. 10kHz
Answer» B. 100kHz
30.

What is the purpose of installing a booster in a transmission line?

A. To supply additional voltage equivalent to the voltage drop in the circuit
B. Reducing the excess voltage when the voltage in the circuit is increased
C. both suitable
D. none in suitable
Answer» D. none in suitable
31.

If there is an oil, petrol or electric fire, then the following equipment will be used to extinguish the fire

A. form type
B. ctc
C. Soda Acid Type
D. carbon dioxide
Answer» C. Soda Acid Type
32.

The function of damping coil in synchronous motor is

A. speed up the motor
B. noise reduction
C. develop only initial torque
D. reduce hunting and develop starting torque
Answer» E.
33.

If the winding is done in the stationary part of the ceiling fan?

A. Both the rotating and winding parts will be rot
B. The winding part will be the rotor
C. the rotating part will be the rotor
D. none of the suitable
Answer» B. The winding part will be the rotor
34.

In a device called a toaster, what is the resistance of the outer filament as compared to the central heating filament?

A. double
B. half
C. equal
D. Quarter
Answer» C. equal
35.

Transformer oil, switch gear, is used in starter?

A. Paper
B. Empire cloth
C. cotton tape
D. insulated oil
Answer» E.
36.

230V single phase line and 3-phase line which supplies power to various domestic consumers and industries are called

A. secondary distribution
B. primary distribution
C. primary transmission
D. secondary transmission
Answer» B. primary distribution
37.

What are the active elements in a lead acid battery?

A. lead peroxide and spongy lead
B. spazzy lad
C. nickel hydride and iron oxide
D. manganese dioxide and carbon
Answer» B. spazzy lad
38.

Generally, there is some loss of electrical power in the electric cable used in temperature instruments, which is due to?

A. heat radiation
B. electric current heat
C. type of cable cover
D. environment around the cable
Answer» C. type of cable cover
39.

What is the advantage of transmitting power at high voltage?

A. power loss is less
B. This reduces the voltage drop across the line impedance
C. current is less
D. suitable all
Answer» E.
40.

Very little damping used in ballistic galvanometers?

A. The first deflection is done to take less
B. The first deflection is used to take more
C. The system is made to oscillate
D. Critical damping of the system is done to
Answer» C. The system is made to oscillate
41.

A in the armature of the rotary converter

A. 90॰
B. 30॰
C. 180॰
D. 120॰
Answer» D. 120॰
42.

What will be the maximum speed of a three phase cage motor at 4% slip?

A. 1440r.p.m.
B. 1500 r.p.m.
C. 2880 r.p.m.
D. 3000 r.p.m.
Answer» D. 3000 r.p.m.
43.

Field winding is done in universal motor (in mixer)?

A. S.E.Wire 20 to 25 SWG
B. with thick wire
C. with thin wire
D. suitable all
Answer» E.
44.

Starter contacts are indicated either for their position or for their function. In such a situation, usually closed contact means that?

A. is open when the relay coil is charged
B. is open when the relay coil is re-charged
C. is in closed state with all the states of the relay
D. is closed when relay coil is charged
Answer» B. is open when the relay coil is re-charged
45.

Capacitor Start-Capacitor Run Induction Motor Originally?

A. is a two-stage induction motor
B. DC. motor is
C. AC motor is
D. 3-phase induction motor
Answer» B. DC. motor is
46.

What is the winding wire of a three phase submersible motor?

A. PVC Super Enamel Plated Brass
B. PVC Super Enamel Plated Iron
C. PVC Super Enamel Plated Copper
D. none of the suitable
Answer» D. none of the suitable
47.

The external screw contacts of screw type lamp holders should always be connected with

A. from the switch wire of the circuit
B. from the phase wire of the circuit
C. from the neutral wire of the circuit
D. from the earth wire of the circuit
Answer» D. from the earth wire of the circuit
48.

S in ceiling fan winding

A. 36SWG
B. 34SWG
C. 35SWG
D. suitable all
Answer» E.
49.

Star-delta and auto transformer starters are used with three phase induction motors because?

A. Three phase induction motors draw 5 to 7 times the full load current at the time of starting
B. Three phase induction motor should not run in opposite direction
C. The starting torque of three phase induction motor is high
D. they attain high speed instantly
Answer» B. Three phase induction motor should not run in opposite direction
50.

In a capacitor-start motor, if an inductor of equal reactance is replaced by the capacitor, then the motor will

A. will burn
B. will run normally
C. won't start
D. none of these
Answer» D. none of these