MCQOPTIONS
Saved Bookmarks
MCQOPTIONS
This section includes 7 Mcqs, each offering curated multiple-choice questions to sharpen your Engineering Metrology knowledge and support exam preparation. Choose a topic below to get started.
| 1. |
If work tolerance is less than 0.09 mm then how much wear tolerance is applied to Go gauge? |
| A. | 10% |
| B. | 20% |
| C. | 30% |
| D. | 40% |
| Answer» B. 20% | |
| 2. |
Which of the following option is correct for the given statements about Gauge design?Statement 1: No Go gauges should put in the condition of maximum impassability in the inspection. |
| A. | nStatement 2: Go plug gauge corresponds to a minimum limit. |
| B. | T, F |
| C. | F, F |
| D. | T, T |
| E. | F, T |
| Answer» D. T, T | |
| 3. |
Which deviations are provided to a new Go plug gauge from the nominal size? |
| A. | One positive deviation |
| B. | One negative deviation |
| C. | Two positive deviations |
| D. | Two negative deviations |
| Answer» D. Two negative deviations | |
| 4. |
What is the use of No Go gauges? |
| A. | Check a single element of a feature |
| B. | Check several dimensions simultaneously |
| C. | Check roundness and size at the same time |
| D. | Check location and size at the same time |
| Answer» B. Check several dimensions simultaneously | |
| 5. |
What is the effect of wear on the size of Go snap gauges? |
| A. | Decrease |
| B. | Increase |
| C. | May increase or decrease |
| D. | No effect |
| Answer» C. May increase or decrease | |
| 6. |
Which of the following can t be done by Go plug gauges? |
| A. | Ensure bore alignability |
| B. | Controls diameter |
| C. | Check straightness of hole |
| D. | Check degree of ovality |
| Answer» B. Controls diameter | |
| 7. |
Go limit applied to which limit condition? |
| A. | Maximum material limit |
| B. | Minimum material limit |
| C. | Lower limit of shaft and upper limit of hole |
| D. | Moderate material limit |
| Answer» B. Minimum material limit | |