Explore topic-wise MCQs in Engineering.

This section includes 4320 Mcqs, each offering curated multiple-choice questions to sharpen your Engineering knowledge and support exam preparation. Choose a topic below to get started.

3251.

_____ is the term used to refer to the process of two modems establishing communications with each other.

A. interacting
B. handshaking
C. connecting
D. linking
E. pinging
Answer» C. connecting
3252.

Resistance is measured in ohm.

A. True
B. False
Answer» B. False
3253.

Your CD-ROM audio cable connects to the:

A. speaker
B. sound card (or motherboard if sound is integrated with it)
C. power supply
D. hard drive
E. BIOS
Answer» C. power supply
3254.

In the Binary numbering system, a (1) represents a jumper being shorted and a (0) represents a jumper being open. On a three-bit jumper block on a SCSI drive, how would an ID of logical 3 be set?

A. 100
B. 010
C. 011
D. . 101
E. None of the above
Answer» D. . 101
3255.

You see the message "invalid media device" after installing a new hard drive. What do you do next?

A. Format
B. Fdisk
C. Partition
D. Add the OS
E. None of the above
Answer» B. Fdisk
3256.

Which monitor would provide the highest level of performance?

A. VGA
B. XGA
C. CGA
D. SVGA
E. None of the above
Answer» E. None of the above
3257.

The DC voltage on most circuit boards is:

A. -12 volts
B. 0 volts
C. +5 volts
D. +12 volts
E. None of the above
Answer» D. +12 volts
3258.

After installing a sound card, the system locks up when a parallel port tape backup unit is also used. What is most likely the problem?

A. IRQ
B. DMA
C. defective LPT port
D. defective tape driver
E. defective sound card.
Answer» B. DMA
3259.

Which of the following items would require you to comply with EPA disposal guidelines?

A. Keyboard
B. System board
C. Power supply
D. Battery
E. None of the above
Answer» E. None of the above
3260.

A workstation has just been installed on an Ethernet LAN, but cannot communicate with the network. What should you check first?

A. reinstall the network protocols
B. reinstall the network interface card driver
C. verify the ip configuration on the workstation
D. verify the link status on the computer's network card
E. None of the above
Answer» E. None of the above
3261.

A hard disk is divided into tracks which are further subdivided into:

A. clusters
B. sectors
C. vectors
D. heads
E. None of the above
Answer» C. vectors
3262.

The floppy drive uses which DMA (direct memory access) channel?

A. 5
B. 4
C. 1
D. 9
E. 2
Answer» F.
3263.

Capacitance is measured in units of:

A. volts
B. amps
C. farads
D. neutrinos
E. anti-neutrinos
Answer» D. neutrinos
3264.

One of the major components of a PC is the Central Processing Unit (CPU) which can be best described as:

A. The device that sends the monitor signals telling it what to display
B. The area that regulates all of the system power usage
C. The area where ail the of the Basic input/output routines are stored
D. The area where all of the processing takes place
E. None of the above
Answer» E. None of the above
3265.

What is the i/o address for com2?

A. 2vb
B. 2f8
C. 8f8
D. 330
Answer» C. 8f8
3266.

When not in use, it is very important to keep 5 1/4 diskettes in _____.

A. Their protective sleeves
B. In a plastic bag
C. On a shelf in an upright position
D. In the floppy drive
E. None of the above
Answer» B. In a plastic bag
3267.

Suppose that the power lamp in on, but the printer will not print. What can you do to correct the problem?

A. Make sure the printer is on line
B. Replace the AC line fuse
C. Turn the printer on and off
D. Replace the ribbon
E. None of the above
Answer» B. Replace the AC line fuse
3268.

You are testing the resistance in Ohms of a fuse on a 15K amp system. If the fuse is good, the meter should read?

A. 0.0
B. 0.2
C. 5.0
D. 2.0
E. None of the above
Answer» B. 0.2
3269.

Type one PC cards:

A. are used only in desktops
B. are no longer being produced
C. are the thinnest of the PC cards
D. don't exist
E. have their own power source
Answer» D. don't exist
3270.

UART is a type of serial chip. Its letters stand for:

A. unidirectional access regarding transmission
B. universal asynchronous receiver/ transmitter
C. upper advanced real transfer
D. unable all restore t-bits
E. use all ROM types
Answer» C. upper advanced real transfer
3271.

A system has two IDE hard drives that are each divided into primary and extended partitions, which drive letter is assigned to the primary partition of the second drive?

A. C
B. D
C. E
D. F
E. None of the above
Answer» C. E
3272.

What would you ask to determine if the display is working?

A. Is there a video cursor or action on the screen?
B. Did the computer beep or chime?
C. Is there high voltage static on the screen
D. All of the above
E. None of the above
Answer» E. None of the above
3273.

What is the modem hang up command?

A. ATHU
B. ATH
C. ATZ
D. ATX
E. None of the above
Answer» C. ATZ
3274.

What expansion types do most pll/plll motherboards support?

A. MCA, PCI
B. ISA, EISA
C. ISA, PCI, AGP
D. ISA, VESA, PCI
E. None of the above
Answer» D. ISA, VESA, PCI
3275.

A capacitor is measured in which of the following units?

A. Volts
B. Ohms
C. Farads
D. Resistance
E. None of the above
Answer» D. Resistance
3276.

When installing an internal modem, all of the following IRQ's can be used except?

A. 5
B. 10
C. 14
D. All of the above
E. None of the above
Answer» D. All of the above
3277.

An IRQ allow interface cards to:

A. Interrupt the CPU to request service
B. Pass data to the CPU to be processed
C. Pass data from one card to another
D. Pass data to the computers memory
E. None of the above
Answer» B. Pass data to the CPU to be processed
3278.

What is the paper feeding technology most commonly associated with dot-matrix printers?

A. sheet feed
B. tractor feed
C. friction feed
D. manual feed
E. None of the above
Answer» C. friction feed
3279.

COM1 is typically represented by which of the following?

A. 15 pin port
B. 9 pin male port
C. 9 pin female port
D. 25 pin male port
E. None of the above
Answer» C. 9 pin female port
3280.

A customer attached an external drive to his notebook computer but the computer is not recognizing it. What should be considered?

A. The cables are attached firmly
B. The external drive has been pre loaded with the appropriate software
C. The external drive was attached before the computer was on
D. The external drive is turned on
E. All of the above
Answer» F.
3281.

"Parity" errors usually indicate bad memory.

A. True
B. False
Answer» B. False
3282.

What device protects against line deficiencies?

A. Surge protector
B. UPS
C. Logic probe
D. Capacitor
E. None of the above
Answer» C. Logic probe
3283.

You can have EISA and MCA devices in the same PC.

A. True
B. False
Answer» C.
3284.

An anti static strap uses a small _____ to make sure you do not become the least path of resistance to the ground?

A. capacitor
B. diode
C. transistor
D. resistor
E. None of the above
Answer» E. None of the above
3285.

Why does a successfully mapped network drive disappear every time you boot the computer?

A. The computer you are connected to has moved
B. You didn't click reconnect on log on
C. The map statement is not in the autoexec.bat file
D. The last drive was not set correctly
E. None of the above
Answer» D. The last drive was not set correctly
3286.

What's the best way to prevent damaging your PC with static electricity?

A. place your PC on a rubber mat
B. wear leather soled shoes
C. periodically touch a safe ground point on the PC to discharge yourself
D. static electricity doesn't really hurt a PC
E. wear an ESD wrist strap
Answer» F.
3287.

What is the highest binary number that can be referred to on a three position jumper block?

A. 4
B. 6
C. F
D. 1
E. None of the above
Answer» E. None of the above
3288.

Which of the following would be a logical first step in troubleshooting a PC?

A. Check the computer CMOS
B. Define the circumstances of the problem
C. Call the vendor
D. Define what applications are being used
E. None of the above
Answer» C. Call the vendor
3289.

The digital multimeter is set for DC, Ohm and 20k. You will read _____ while measuring a good 2 amp fuse.

A. 0.00
B. 0.02
C. 0.20
D. 2.00
E. None of the above
Answer» B. 0.02
3290.

A 25-pin female connector on the back of your computer will typically be:

A. Serial port 1
B. A parallel port
C. Docking
D. COM2 port
E. None of the above
Answer» C. Docking
3291.

Changes made periodically to a system, after its implementation, is known as system

A. analysis
B. design
C. development
D. maintenance
E. none of the above
Answer» E. none of the above
3292.

Modems use transmission.

A. synchronous
B. asynchronous
C. timed interval
D. ata
E. bank
Answer» C. timed interval
3293.

A 6xx indicates a problem with the:

A. floppy drive
B. hard drive
C. keyboard
D. CD ROM
E. All of the above
Answer» B. hard drive
3294.

Which of the following is not an advantage of the structured approach to system development?

A. it focuses on the physical aspects of the system
B. the system specification is very graphic
C. the user area is studied thoroughly
D. the documentation is Cumulative
E. None of the above
Answer» B. the system specification is very graphic
3295.

The instruction "If it's raining outside, then take an umbrella to work" is an example of the _____ structure,

A. Control
B. Repetition
C. Selection
D. Sequence
E. Switching
Answer» D. Sequence
3296.

Programmers use _____ to organize and summarize the results of their problem analysis.

A. Flowcharts
B. Input charts
C. IPO charts
D. Output charts
E. Processing charts
Answer» D. Output charts
3297.

Which of the following affects the extent to which you are involved with the system development life cycle in your company?

A. your job description
B. size of the organization
C. your relevant experience
D. All of the above
E. None of the above
Answer» F.
3298.

The reservation system of Indian railways is an example of

A. transaction processing system
B. Interactive decision support system
C. management controls system
D. expert system
E. None of the above
Answer» B. Interactive decision support system
3299.

A sound card typically uses which IRQ?

A. 6
B. 5
C. 15
D. 1
E. it doesn't use an IRQ
Answer» C. 15
3300.

During preventative maintenance on a dot matrix printer, do NOT lubricate:

A. Platen assembly
B. Print head pulley
C. Print head pins
D. Paper advance gear bushings
E. None of the above
Answer» D. Paper advance gear bushings