Explore topic-wise MCQs in Engineering Drawing.

This section includes 4 Mcqs, each offering curated multiple-choice questions to sharpen your Engineering Drawing knowledge and support exam preparation. Choose a topic below to get started.

1.

A cam should be designed only using uniform rise and fall within first half of cam profile, the remaining is dwell period, and without any dwell period in between the rise-fall periods and rise and fall periods should be same. The maximum rise in follower is 35 mm. How much the follower will rise when the follower is 240 degrees from its initial position of a cam?

A. 17.5
B. 11.6
C. 0
D. 23.3
Answer» D. 23.3
Discussion
2.

A cam should be designed only using uniform rise and fall within the second half of cam profile, the first half is dwell period, without any dwell period in between the rise and fall periods and rise and fall periods should be same. The maximum rise in follower is 55 mm. How much the follower will rise when the follower is 240 degrees from its initial position of a cam?

A. 18.3
B. 0
C. 27.5
D. 36.6
Answer» B. 0
Discussion
3.

A cam should be designed only using uniform rise and fall within the second half of cam profile, the first half is dwell period, without any dwell period in between the rise and fall periods and rise and fall periods should be same. The maximum rise in follower is 45 mm. How much the follower will rise when the follower is 120 degrees from its initial position of a cam?

A. 15
B. 30
C. 20
D. 0
Answer» E.
Discussion
4.

A cam should be designed only using uniform rise and fall within half of the cam, the remaining is dwell period, and without any dwell period in between the rise-fall periods and rise and fall periods should be same. The maximum rise in follower is 45 mm. How much the follower will rise when the follower is 45 degrees from its initial position of a cam?

A. 22.5
B. 0
C. 30
D. 15
Answer» B. 0
Discussion