Width (L) of overlap of sheets is equal to ________ when d is the diam – McqOptions

MCQOPTIONS

1.	Width (L) of overlap of sheets is equal to ________ when d is the diameter of a rivet in case of single-riveted lap joint?
A.	2d
B.	3d
C.	4d
D.	5d
Answer» C. 4d

Discussion

No Comment Found

Related MCQs

The flat ends of a boiler are prevented from bulging out and are strengthened by means of _________
In butt joint when two straps are used the thickness varies between _______ to ________ (T is the thickness of plate to be connected).
In butt joint when one strap is used the thickness varies between _______ to ________ (T is the thickness of plate to be connected).
In zigzag lap joint formation when P is the pitch between the rivets, the distance between the rows of rivets should not be less than _____
Width (L) of overlap of sheets is equal to ________ when d is the diameter of a rivet in case of single-riveted lap joint.
What type of failure will occur when rivets are smaller than necessary?
Two steel rods connected by cotter joint are subjected to 50 kN load each. What is the minimum diameter required of the rods? (Given: Yielding Stress= 400N/mm² ; Factor of Safety=6)
Which of the following isn’t a main part of rivet?
IN_ZIGZAG_LAP_JOINT_FORMATION_WHEN_P_IS_THE_PITCH_BETWEEN_THE_RIVETS,_THE_DISTANCE_BETWEEN_THE_ROWS_OF_RIVETS_SHOULD_NOT_BE_LESS_THAN______?$
RIVETING_IS_NOT_RECOMMENDED_FOR_ALUMINIUM_ALLOYS.?$