Why_large_or_complex_castings_require_multiple_in-gates? – McqOptions

MCQOPTIONS

1.	Why_large_or_complex_castings_require_multiple_in-gates?
A.	To make smooth surface finish of the casting
B.	To make uniform flow
C.	To have high strength of the casting
D.	To have good toughness of the casting
Answer» C. To have high strength of the casting

Discussion

No Comment Found

Related MCQs

A mould has a down sprue length of 0.2 meters. The velocity of metal in meter/second at gate will be?
Time required to fill the mould by vertical gating system is?
If the volume to surface area ratio is 2 for riser and for casting it is 4, then the freezing ratio is?
If velocity of metal flow at gate is 4m/sec, volume of mould is .1 cubic meters and the cross-sectional area of gate is 0.002 cubic meters then the time required to fill up the mould in seconds is?
Which of the following is not a type of riser?
In the gate area for non-pressurized casting gating ratio a:b:c? (gating ratio = a: b: c where, a = cross-sectional area of sprue, b: cross-sectional area of runner, c = total cross-sectional area of ingates).
In which type of gating system aspiration effect takes place?
Why large or complex castings require multiple in-gates?
What is the ratio of width to the depth of in-gates in general?
Smallest in-gate area in the pressurized gating system causes_____