Which test is conducted to measure the endurance limit of the material

1.	Which test is conducted to measure the endurance limit of the material?
A.	Creep test
B.	Fatigue test
C.	Compression test
D.	Hardness test
Answer» C. Compression test

Discussion

No Comment Found

Related MCQs

What is the process of heating the metal in the furnance to a temperature slightly above the upper critical temperature and cooling slowly In the furnance.
A rod, which tapers uniformly from 5cm diameter to 3cm diameter in a length of 50cm, is subjected to an axial load of 6000N. if E = 2,00,000 N/mm², what will be the extension of the rod?
If a bar of two sections of different diameters of same length are in a line and P load is acting axially on them then what will be the change in length of the bar?
A uniform, slender cylindrical rod is made of a homogeneous and isotropic material. The rod rests on a frictionless surface. The rod is heated uniformly. If the radial and longitudinal thermal stress are represented by σx and σz, then ___________
A composite bar have four sections each of length 100mm, 150mm, 200mm, 250mm. When force is applied, all the sections causes an elongation of 0.1mm. What will the resultant strain in the bar?
A brass bar, having cross sectional area of 150mm², is subjected to axial force of 50kN. What will be the total strain of bar if E= 1.05 x 104 N/mm²?
A solid uniform metal bar is hanging vertically from its upper end. Its elongation will be _________
A cube with a side length of 1m is heated uniformly a degree celcius above the room temperature and all the sides are free to expand. What will be the increase in the volume of the cube? Consider the coefficient of thermal expansion as unity.
A mild steel wire 5mm in diameter and 1m ling. If the wire is subjected to an axial tensile load 10kN what will be its extension?
Photo stress method is ___________

Which test is conducted to measure the endurance limit of the material?

Discussion

No Comment Found

Related MCQs

Reply to Comment