Which of the following shapes can be produced using Electro discharge – McqOptions

MCQOPTIONS

1.	Which of the following shapes can be produced using Electro discharge machining?
A.	Complex shapes
B.	Simple shapes
C.	All of the mentioned
D.	None of the mentioned
Answer» D. None of the mentioned

Discussion

No Comment Found

Related MCQs

WHAT_ARE_THE_VALUES_OF_OVERCUTS_LEFT_BEHIND_AFTER_DRILLING_OF_WORK_PIECE??$
When compared to the conventional abrasive sawing, how many times faster is the MRR?$
Electro discharge sawing is an application of EDM which employs _____ as tool material.$
What are the recast layer thickness values obtained in ED sawing?
What are the values of finish obtained by machining work piece thorough Electro discharge sawing?
How much amount of burr is produce while machined using Electro discharge sawing?
What are range of diameter values obtained by drilling using EDM?
What are the values of general feed rates used for drilling in EDM?
Which type of holes can be produced through drilling using Electro discharge machining?
The dielectric fluid is flushed in thorough which part of the electrode in drilling in EDM?