Which of the following moulds or moulding is also known as sodium sili – McqOptions

MCQOPTIONS

1.	Which of the following moulds or moulding is also known as sodium silicate process.
A.	Shell moulding
B.	Permanent moulding
C.	Slush moulding
D.	Co<sub>2</sub> moulding
Answer» E.

Discussion

No Comment Found

Related MCQs

WHICH_OF_THE_FOLLOWING_ADDITIVES_ARE_ADDED_TO_THE_SAND_IN_CO2_MOULDING_FOR_THE_IMPROVEMENT_IN_COLLAPSIBILITY_OF_THE_SAND??$
Moisture from the mould can be removed by using of dryer or heater in Co2 moulding.$
Co2_moulding_process_is_an_ideal_process,_where_speed_and_flexibility_is_the_prime_requirement.$
Co2 moulding is a kind of sand moulding, but it is not economical than the green sand moulding.
It is very safe to use Co2 in Co2 moulding, so it eliminates the use of any shielding apparatus?
Sometimes over-gassing can cause the sticking of pattern to the mould in Co2 moulding.
Additives can be used for the non-ferrous application to avoid the poor collapsibility of the mould.
How much time (in a minute) is usually required for the passing of Co2 through the mould?
Continuous passing of Co2 through the mould can decrease the strength of mould and results in a weak mould.
How much percentage of sodium silicate (Na2SiO3) is added to the sand mixture in Co2 moulding?