Which of the following is usually adopted for contraction and construc – McqOptions

MCQOPTIONS

1.	Which of the following is usually adopted for contraction and construction joints?
A.	Rubber water bars
B.	V-shape metal bars
C.	PVC water bars
D.	Z-shape metal bars
Answer» D. Z-shape metal bars

Discussion

No Comment Found

Related MCQs

The use of sealing compounds for vertical joints is very successful.
What is the most common metal used for water stops?
In case of the sealing joint, the lower part of the joint is occupied by joint filler.
Joint sealing compounds are impermeable ductile materials which are required to ___________________
Which of the following is sometimes used in expansion joints to avoid the risk of fault in an embedded water bar?
What provides a permanent watertight seal during the whole range of joint movement?
Which of the following can be used as support for an effective joint sealing compound in floor and floor joints?
What is the maximum expansion or contraction allowed for the joint filler material with an initial gap of about 30 mm?
The expansion joints in floors and walls should normally be provided at a spacing of not more than ___________
In reinforced concrete floors, the movement joints should normally be spaced at a maximum spacing of ____________