Which of the following components are inspected by a Tool maker's micr

1.	Which of the following components are inspected by a Tool maker's microscope?
A.	gauges
B.	screw threads
C.	dies and fixtures
D.	all of the above
Answer» E.

Discussion

No Comment Found

Related MCQs

Which of the following statements is true? 1. P and nP charts cannot use limit gauges 2. P charts are difficult to understand 3. P charts cannot recognize different degrees of defectiveness in units
Which of the following statements is true for LVDT?
Which of the following statements is/are false? 1. Fault tree analysis method is used to determine reliability of product 2. The goal of Six Sigma is to reduce number of defects to 2.4 parts per billion 3. Six sigma is represented by normal distribution curve 4. Poka yoke is a policy which prevents occurrence of human errors
Which of the following statements is/are false for Co-ordinate measuring machine?
Which of the following statements is/are true? 1. Gross errors are known as compensating errors 2. Systematic errors are caused due to system interaction errors 3. Probability laws are followed by systematic errors
Which of the following statements is/are true? 1. Probability of acceptance decreases if acceptance number increases, when sampling size is kept constant 2. Indifferent quality range is the range between lot tolerance percent defective and acceptable quality level 3. Operating characteristics curve is the curve plotted between probability of acceptance and indifferent quality range
Which of the following statements is/are true? 1. Trend type of control chart pattern shows continuous movement of points upwards and downwards 2. Trend pattern occurs due to change in inspection method 3. Downward trend indicates wear of parts
Which of the following statements is/are true according to Deming's Deadly Diseases?
Which of the following statements is/are true for sampling inspection?
Which of the following strategies of Deming's fourteen points is included into category of Management commitment?

Which of the following components are inspected by a Tool maker's microscope?

Discussion

No Comment Found

Related MCQs

Reply to Comment